12611
1.REMOVE NO. 1 ENGINE COVER
2.DRAIN ENGINE OIL
3.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
12101
4.REMOVE OIL PAN SUB-ASSEMBLY
Remove the 4 bolts from the oil pan sub-assembly.
Using an E10 "TORX" socket wrench, remove the 20 bolts from the oil pan sub-assembly.
Pry the oil pan sub-assembly at the locations shown in the illustration to remove the oil pan sub-assembly.
Be careful not to damage the contact surfaces of the oil pan sub-assembly and cylinder block sub-assembly.
15104
5.REMOVE OIL STRAINER SUB-ASSEMBLY
Remove the 2 bolts and oil strainer sub-assembly.
6.REMOVE OIL PUMP WITH VACUUM PUMP ASSEMBLY
Using an E10 "TORX" socket wrench, remove the 4 bolts from the oil pump with vacuum pump assembly.
Remove the oil pump drive chain sub-assembly from the oil pump drive shaft gear, and then remove the oil pump with vacuum pump assembly.
Do not drop the oil pump drive chain sub-assembly into the gap between the rear gear case and cylinder block sub-assembly.
Suspend the oil pump drive chain with a string or equivalent.
15163
7.REMOVE OIL PUMP DRIVE SHAFT GEAR
Using SST and a T45 "TORX" socket wrench, remove the bolt and oil pump drive shaft gear.
15115
8.REMOVE OIL PUMP COVER
Detach the claw to remove the oil pump cover.