Home › Drivetrain › CLUTCH › CLUTCH RELEASE CYLINDER(for 2WW) › from 2015.10
RM3090E _52 Drivetrain _008754 CLUTCH _0220759 CLUTCH RELEASE CYLINDER(for 2WW) A

CLUTCH  CLUTCH RELEASE CYLINDER(for 2WW)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

Hide 51441 4.REMOVE NO. 1 ENGINE UNDER COVER

Hide 28899 7.REMOVE BATTERY INSULATOR

Hide 8.REMOVE BATTERY

Hide 74431 9.INSTALL BATTERY TRAY

Hide 74414B 11.REMOVE BATTERY BRACKET REINFORCEMENT

Hide 12.REMOVE AIR CLEANER CAP SUB-ASSEMBLY WITH AIR CLEANER HOSE ASSEMBLY

Hide 17275A 14.DISCONNECT COMPRESSOR OUTLET ELBOW

Hide 17342D 17.DISCONNECT NO. 2 AIR HOSE

Hide 31482 19.DISCONNECT CLUTCH RELEASE CYLINDER TO FLEXIBLE HOSE TUBE

a.
C299390

Using a 10 mm union nut wrench, disconnect the clutch release cylinder to flexible hose tube.

HINT:

Use a container to catch the fluid.



Hide 31470 20.REMOVE CLUTCH RELEASE CYLINDER ASSEMBLY

a.
C299391

Remove the 2 bolts, clutch release cylinder assembly from the manual transaxle assembly.