The ECM determines the vehicle inclination based on a signal from the yaw rate and acceleration sensor (airbag sensor assembly). If a malfunction of the yaw rate and acceleration sensor (airbag sensor assembly) is determined based on a malfunction signal from the skid control ECU (brake actuator assembly), the ECM stores this DTC.
The yaw rate and acceleration sensor (airbag sensor assembly) signal is sent to the skid control ECU (brake actuator assembly) via CAN communication.
If CAN communication DTCs are output, perform troubleshooting for those DTCs first.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P1586 | Acceleration Sensor Malfunction | 1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
DTC Detection Condition 1: 1.
The ignition switch is ON. 2.
At a vehicle speed 30 km/h (19 mph) or more, the difference between longitudinal G calculated based on the yaw rate and acceleration sensor (airbag sensor assembly) (G sensor) value and longitudinal G calculated based on the vehicle speed exceeds 0.35 G for 60 seconds or more. 3.
3 seconds or more 4.
1-trip detection logic DTC Detection Condition 2: 1.
The ignition switch is ON. 2.
The yaw rate and acceleration sensor (airbag sensor assembly) signal does not change 16 times or more while the vehicle speed decreases from 30 km/h (19 mph) to 0 km/h (0 mph). 3.
3 seconds or more 4.
1-trip detection logic |
·
Yaw rate and acceleration sensor (Airbag sensor assembly) ·
Skid control ECU (Brake actuator assembly) ·
CAN communication system |
Does not come on | DTC stored |
Refer to DTC P1585
Click hereDrivetrain>K114 MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>P1585
Perform initialization when parts related to the continuously variable transaxle are replaced.
Click hereDrivetrain>K114 MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION
Check that no DTCs are stored after performing initialization.
Click hereDrivetrain>K114 MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DTC CHECK / CLEAR
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC U0129 is not output | A |
| DTC U0129 is output | B |
A
B
for LHD with Central Gateway ECU:
for RHD with Central Gateway ECU:
for LHD without Central Gateway ECU:
for RHD without Central Gateway ECU:
Connect the GTS to the DLC3.
Turn the GTS on.
Turn the ignition switch to ON.
Clear the DTCs.
Click hereDrivetrain>K114 MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DTC CHECK / CLEAR
Perform a road test where the vehicle is driven at 30 km/h (18 mph) or more, the brakes are applied at least 16 times and the vehicle is finally stopped.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs using the GTS.
If any DTCs other than P1586 are output, perform troubleshooting for those DTCs first.
| Result | Proceed to |
|---|---|
| Only DTC P1586 is output | A |
| DTC P1586 and other DTCs are output | B |
A
B
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Primary.
In accordance with the display on the GTS, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| G Sensor | Converted output voltage of G sensor | Min.: 0 V
Max.: 79.998 V |
Displays converted voltage of G sensor
·
2.31 V to 2.69 V: Vehicle on level ground ·
1.88 V to 2.5 V: Decelerating ·
2.5 V to 3.11 V: Accelerating ·
Set to 1.87 V: G sensor malfunction ·
Set to 1.87 V: Communication malfunction |
- |
| Tester Display |
|---|
| G Sensor |
| Result | Proceed to |
|---|---|
| Data display is not within Normal Condition range | A |
| Data display is within Normal Condition range | B |
A
B
Replace the yaw rate and acceleration sensor (airbag sensor assembly).
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT