Home › Engine / Hybrid System › 2WW FUEL › FUEL PRESSURE DISCHARGE VALVE › from 2015.10
RM3090E _51 Engine / Hybrid System _044374 2WW FUEL _0221821 FUEL PRESSURE DISCHARGE VALVE A

2WW FUEL  FUEL PRESSURE DISCHARGE VALVE  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Always be sure to check the tightening torque.

·

If the pressure lines are leaking after installation, they must be replaced.

·

Do not overtighten the pressure lines.



PROCEDURE

Hide 23990 1.INSTALL PRESSURE DISCHARGE VALVE ASSEMBLY

HINT:

Perform "Fuel PCV Compensation Value Reset" after replacing the pressure discharge valve assembly.

Click hereEngine / Hybrid System>2WW ENGINE CONTROL>ECD SYSTEM>INITIALIZATION


a.

Check the threads and sealing surfaces for damages prior to installing the pressure discharge valve assembly.


b.

Make sure the pressure discharge valve assembly, sealing surfaces and threads are free from dirt and any foreign matter before performing work. Lightly grease the threads on the pressure discharge valve assembly.


c.

Step 1:

Screw in the pressure discharge valve assembly by hand. Then tighten the pressure discharge valve assembly.

Torque:
60 N*m (612 kgf*cm, 44 ft.*lbf)


d.

Step 2:

Loosen the pressure discharge valve assembly by 90°.


e.

Step 3:

Tighten the pressure discharge valve assembly.

Torque:
85 N*m (867 kgf*cm, 63 ft.*lbf)


Hide 23810A 2.INSTALL COMMON RAIL ASSEMBLY

Hide 3.PERFORM INITIALIZATION

a.

Perform "Fuel PCV Compensation Value Reset" after replacing the pressure discharge valve assembly.

Click hereEngine / Hybrid System>2WW ENGINE CONTROL>ECD SYSTEM>INITIALIZATION