Home › Engine / Hybrid System › 2WW FUEL › COMMON RAIL › from 2015.10
RM3090E _51 Engine / Hybrid System _044374 2WW FUEL _0221822 COMMON RAIL A

2WW FUEL  COMMON RAIL  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

Always be sure to check the tightening torque.

·

If the pressure lines are leaking after installation, they must be replaced.

·

Do not overtighten the pressure lines.



PROCEDURE

Hide 23990 1.INSTALL PRESSURE DISCHARGE VALVE ASSEMBLY

Hide 89458A 2.INSTALL FUEL PRESSURE SENSOR

Hide 23810A 3.INSTALL COMMON RAIL ASSEMBLY

a.

Install the common rail assembly to the cylinder head cover sub-assembly.


b.

Using an E10 "TORX" socket wrench, install the 2 common rail assembly brackets with the 4 bolts.

HINT:

Refer to "SPECIFICATIONS - STANDARD BOLT" for the tightening torque.



c.

Connect the fuel return tube.


d.

Connect the pressure discharge valve assembly connector.


e.

Connect the fuel pressure sensor connector.


Hide 4.INSTALL FUEL INLET PIPE SUB-ASSEMBLY

NOTICE:
·

If the pressure lines are leaking after installation, they must be replaced.

·

Do not overtighten the pressure lines.



a.
A354353C01
1.542,1.125 1.813,1 1.813,1 1.969,1 false 0.5,1.865 0.802,1.865 true 0.875,2.708 0.875,2.521 0.875,2.521 1.302,2.344 true 0.292,1.781 0.479,1.979 0.188,0.198 10 true *1 0.802,2.75 1.01,2.948 0.208,0.198 10 true *2 2.021,0.927 2.479,1.125 0.458,0.198 10 false SST 2.094,1.313 2.25,1.51 0.156,0.198 10 true 1 1.875,3.052 1.99,3.24 0.115,0.188 10 true 2
*1 Rubber Grommet
*2 Rubber Mount


Install the fuel inlet pipe sub-assembly to the rubber grommet and rubber mount shown in the illustration.

NOTICE:

Install the rubber mount and rubber grommet at the correct positions on the pressure line.



b.

Temporarily install the union nuts at the fuel supply pump assembly end and common rail assembly end of the fuel inlet pipe sub-assembly by hand.


c.

Using SST, tighten the union nuts at the fuel supply pump assembly end and common rail assembly end of the fuel inlet pipe sub-assembly in the order shown in the illustration.

SST:

PZ4TB-04959-10


Torque:
24 N*m (245 kgf*cm, 18 ft.*lbf)

NOTICE:

Reset SST in a timely manner to prevent bending of pressure lines.



Hide 5.INSTALL INJECTION PIPE SUB-ASSEMBLY