Wear protective gloves. Sharp areas on the seatback frame, seat cushion frame and reclining adjuster may injure your hands.
87510P
1.INSTALL REAR SEATBACK HEATER ASSEMBLY LH
Using a tacker, install the rear seatback heater assembly LH with 16 new tack pins as shown in the illustration.
Secure the rear seatback heater assembly LH so that it does not bend or stretch.
Set the rear seatback heater assembly LH so that the nichrome wire is on the separate type rear seatback cover side.
Pass the wire harness through the hole of the separate type rear seatback cover.
71078S
2.INSTALL SEPARATE TYPE REAR SEATBACK COVER
3.INSTALL SEPARATE TYPE REAR SEATBACK COVER WITH PAD
71882A
4.INSTALL REAR SEATBACK BOARD LH
71303C
5.INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY RH (w/ Child Restraint System Guide)
71304C
6.INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY LH (w/ Child Restraint System Guide)
72995A
7.INSTALL REAR SEAT COVER
72996
8.INSTALL REAR SEATBACK COVER RH
71016A
9.INSTALL REAR SEAT CUSHION FRAME SUB-ASSEMBLY LH
72996A
10.INSTALL REAR SEATBACK COVER
11.INSTALL SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD
71694
12.INSTALL REAR SEAT LOWER CUSHION HINGE COVER LH
71693A
13.INSTALL REAR SEAT NO. 3 CUSHION HINGE COVER
72526A
14.INSTALL RECLINING ADJUSTER RELEASE HANDLE LH
71846B
15.INSTALL REAR SEATBACK NO. 1 BOARD CAP
72831B
16.INSTALL REAR SEAT NO. 1 CENTER ARMREST PLATE
72830
17.INSTALL REAR SEAT CENTER ARMREST ASSEMBLY
72868
18.INSTALL CENTER ARMREST HINGE COVER RH
73340C
19.INSTALL REAR CENTER SEAT LAP TYPE BELT ASSEMBLY LH
71960B
20.INSTALL REAR SEAT CENTER HEADREST ASSEMBLY
71940A
21.INSTALL REAR SEAT HEADREST ASSEMBLY
22.INSTALL REAR SEAT ASSEMBLY LH