Wear protective gloves. Sharp areas on the seatback frame, seat cushion frame and reclining adjuster may injure your hands.
87510P
1.INSTALL REAR SEATBACK HEATER ASSEMBLY RH
Using a tacker, install the rear seatback heater assembly RH with 16 new tack pins as shown in the illustration.
Secure the rear seatback heater assembly RH so that it does not bend or stretch.
Set the rear seatback heater assembly RH so that the nichrome wire is on the separate type rear seatback cover side.
Pass the wire harness through the hole of the separate type rear seatback cover.
71077S
2.INSTALL SEPARATE TYPE REAR SEATBACK COVER
3.INSTALL SEPARATE TYPE REAR SEATBACK COVER WITH PAD
71881
4.INSTALL REAR SEATBACK BOARD RH
71303C
5.INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY RH (w/ Child Restraint System Guide)
71304C
6.INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY LH (w/ Child Restraint System Guide)
72995A
7.INSTALL REAR SEAT COVER
72996
8.INSTALL REAR SEATBACK COVER RH
71015A
9.INSTALL REAR SEAT CUSHION FRAME SUB-ASSEMBLY RH
72996A
10.INSTALL REAR SEATBACK COVER
11.INSTALL SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD
71692E
12.INSTALL REAR SEAT NO. 2 CUSHION HINGE COVER
71691E
13.INSTALL REAR SEAT NO. 1 CUSHION HINGE COVER
72525A
14.INSTALL RECLINING ADJUSTER RELEASE HANDLE RH
71845D
15.INSTALL REAR SEAT COVER CAP RH
71940A
16.INSTALL REAR SEAT HEADREST ASSEMBLY
17.INSTALL REAR SEAT ASSEMBLY RH