Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › from 2015.10
RM3090E _55 Steering _008772 POWER ASSIST SYSTEMS _0049011 POWER STEERING SYSTEM Y

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use these procedures to troubleshoot the power steering system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
a.

Measure the voltage of the battery.

Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.


b.

Using the GTS, inspect battery voltage reduction history "Battery Voltage Lo Record" in the Data List (Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DATA LIST / ACTIVE TEST).


Result:
Proceed to
NEXT



NEXT

3.CHECK DTC AND FREEZE FRAME DATA*
3.CHECK DTC AND FREEZE FRAME DATA*
HINT:

Refer to DTC Check / Clear.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR


Result:
Proceed to
NEXT



NEXT

4.PROBLEM SYMPTOM CONFIRMATION
4.PROBLEM SYMPTOM CONFIRMATION
Result:
Proceed to
Symptom does not occur
Symptom occurs



Symptom does not occur

5.SYMPTOM SIMULATION

Symptom occurs

6.CHECK CAN COMMUNICATION SYSTEM*
5.SYMPTOM SIMULATION
Result:
Proceed to
NEXT



NEXT

6.CHECK CAN COMMUNICATION SYSTEM*
6.CHECK CAN COMMUNICATION SYSTEM*
a.

Check for DTCs.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR

Result:
Proceed to
CAN communication system DTC is not output
CAN communication system DTC is output


HINT:
·

If any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.

·

If communication to the power steering ECU assembly cannot be established through the GTS, inspect terminals CANH and CANL of the DLC3 and the power steering ECU assembly, and the IG circuit of the power steering ECU assembly.





CAN communication system DTC is not output

7.CHECK FOR DTC*

CAN communication system DTC is output

7.CHECK FOR DTC*
a.

Check for DTCs.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR

HINT:

Refer to Diagnostic Trouble Code Chart when any DTCs are output.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DIAGNOSTIC TROUBLE CODE CHART


Result:
Proceed to
DTC is not output
DTC is output




DTC is not output

8.PROBLEM SYMPTOMS TABLE

DTC is output

10.REPAIR OR REPLACE
8.PROBLEM SYMPTOMS TABLE
a.

Refer to Problem Symptoms Table.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>PROBLEM SYMPTOMS TABLE

Result:
Proceed to
Fault is not listed in Problem Symptoms Table
Fault is listed in Problem Symptoms Table




Fault is not listed in Problem Symptoms Table

9.OVERALL ANALYSIS AND TROUBLESHOOTING*

Fault is listed in Problem Symptoms Table

10.REPAIR OR REPLACE
9.OVERALL ANALYSIS AND TROUBLESHOOTING*


Result:
Proceed to
NEXT



NEXT

10.REPAIR OR REPLACE
10.REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

11.CONFIRMATION TEST
11.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END