Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › from 2015.10
RM3090E_55Steering_008772POWER ASSIST SYSTEMS_0049011POWER STEERING SYSTEMS
POWER ASSIST SYSTEMS POWER STEERING SYSTEM DIAGNOSTIC TROUBLE CODE CHART
Power Steering System
DTC No.
Detection Item
Warning Indicate
Return-to-normal Condition
Link
C1511/11
Torque Sensor 1 Malfunction
On
Ignition switch ON again
C1512/11
Torque Sensor 2 Malfunction
On
Ignition switch ON again
C1513/11
Torque Sensor Deviation Excessive
On
Ignition switch ON again
C1514/11
Torque Sensor Power Supply Voltage Malfunction
On
Ignition switch ON again
C1521/25
Short in Motor Circuit
On
Ignition switch ON again
C1524/24
Motor Circuit Malfunction
On
Ignition switch ON again
C1528/12
Motor Rotation Angle Sensor Malfunction
On
Ignition switch ON again
C1531/25
ECU Malfunction
On
Ignition switch ON again
C1532/25
ECU Malfunction
On
Ignition switch ON again
C1533/25
Temperature Sensor Circuit is Low or High
Off
After normal judgment
C1534/25
EEPROM Malfunction
Torque and motor rotation angle sensor adjustment is set to the default value and control is continued. In this case, the warning light illuminates.
After normal judgment
C1541/13
Vehicle Speed Signal
On
Ignition switch ON again
C1551/25
IG Power Supply Voltage Malfunction
On
Ignition switch ON again
C1552/22
PIG Power Supply Voltage Malfunction
On
Ignition switch ON again
C1554/23
Power Supply Relay Failure
On
Ignition switch ON again
C1555/25
Motor Relay Welding Failure
On
Ignition switch ON again
C1581/26
Assist Map Number Un-Writing
On
Assist map written
C1582/26
Assist Map Number Mismatch
Off
Assist map written
U0100/41
Lost Communication with ECM/PCM "A"
When an error occurs during steering assist, the warning light does not illuminate. For errors that occur before assist (at the time of the decision to start assist), the warning light illuminates.
After normal confirmation
U0129/42
Lost Communication with Brake System Control Module