When the air conditioning amplifier assembly is turned on, a magnet clutch assembly signal is sent from the MGC terminal of the air conditioning amplifier assembly. Then, the MG/CLT relay turns on to operate the magnet clutch assembly.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Remove the MG/CLT relay from the No. 2 engine room relay block.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 - 5 | Battery voltage is not applied to terminals 1 and 2 | 10 kΩ or higher |
| Battery voltage is applied to terminals 1 and 2 | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the cooler compressor assembly.
Click hereVehicle Interior>HEATING / AIR CONDITIONING>COMPRESSOR(for 2AR-FE)>REMOVAL
Apply battery voltage to the magnet clutch assembly and check the operation of the magnet clutch assembly.
| Measurement Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 3 (MG+)
Battery negative (-) → Body ground |
Magnet clutch assembly operating sound can be heard, and magnet clutch hub and rotor lock. |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the MG/CLT relay from the No. 2 engine room relay block.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| MG/CLT relay terminal 1 - Body ground | Ignition switch ON | 11 to 14 V |
| MG/CLT relay terminal 5 - Body ground | Always | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Rear view of wire harness connector
(to Air Conditioning Amplifier Assembly) |
Disconnect the air conditioning amplifier assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G81-20 (MGC) - Body ground | Ignition switch off | Below 1 V |
| G81-20 (MGC) - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the MG/CLT relay from the No. 2 engine room relay block.
Disconnect the B68 magnet clutch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| MG/CLT relay terminal 3 - B68-3 (MG+) | Always | Below 1 Ω |
| B68-3 (MG+) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG