Home › Audio / Visual / Telematics › AUDIO / VIDEO › AMPLIFIER ANTENNA › from 2015.10
RM3090E _56 Audio / Visual / Telematics _008775 AUDIO / VIDEO _0227593 AMPLIFIER ANTENNA A

AUDIO / VIDEO  AMPLIFIER ANTENNA  INSTALLATION  


PROCEDURE

Hide 86077 1.INSTALL ANTENNA COVER KIT

a.

When reusing the No. 1 amplifier antenna assembly:

NOTICE:

New seals have specific front and rear ends. Make sure to install the seal in the correct direction, as incorrect installation may cause water leakage, etc.


i.
E332883

Before removing the peeling paper from the seal, place the seal on the antenna as shown in the illustration and check the front and rear ends.


ii.
E319016

Remove the peeling paper, align the mark on the seal with the mark on the front of the antenna and install the seal to the antenna.



b.
E332829N01
1.448,0.167 1.656,0.375 0.208,0.208 10 true (1) 1.115,0.604 1.323,0.813 0.208,0.208 10 true (2)

Attach the claws and guides to install the No. 1 amplifier antenna assembly as indicated by the arrows in the order shown in the illustration.


Hide 86300B 2.INSTALL NO. 1 AMPLIFIER ANTENNA ASSEMBLY

a.
E332830

Temporarily install the No. 1 amplifier antenna assembly to the vehicle.


b.
E332825

Insert the a new washer and holder to install the No. 1 amplifier antenna with the bolt.

Torque:
9.5 N*m (97 kgf*cm, 84 in.*lbf)


c.
E332824

Connect the connector.


Hide 63310 3.INSTALL ROOF HEADLINING ASSEMBLY

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).