Home › Audio / Visual / Telematics › AUDIO / VIDEO › AMPLIFIER ANTENNA › from 2015.10
RM3090E _56 Audio / Visual / Telematics _008775 AUDIO / VIDEO _0227593 AMPLIFIER ANTENNA A

AUDIO / VIDEO  AMPLIFIER ANTENNA  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 63310 3.REMOVE ROOF HEADLINING ASSEMBLY

Hide 86300B 4.REMOVE NO. 1AMPLIFIER ANTENNA ASSEMBLY

a.
E332824

Disconnect the connector.


b.
E332825

Remove the bolt and then remove the washer and holder.


c.
E332826

Remove the No. 1 amplifier antenna assembly of the vehicle outside.


Hide 86077 5.REMOVE ANTENNA COVER KIT

a.
E332827N01
1.104,0.656 1.333,0.865 0.229,0.208 10 true (1) 1.5,0.333 1.729,0.542 0.229,0.208 10 true (2)

Detach the claws and guides and remove the No. 1 amplifier antenna assembly as indicated by the arrows in the order shown in the illustration.


b.

When reusing the No. 1 amplifier antenna assembly:

i.
E332828

Remove the seal.