Home › Power Source / Network › NETWORKING › NETWORK GATEWAY ECU(for RHD) › from 2015.10
RM3090E _57 Power Source / Network _008434 NETWORKING _0227721 NETWORK GATEWAY ECU(for RHD) A

NETWORKING  NETWORK GATEWAY ECU(for RHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55606 3.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55545 4.REMOVE FUSE BOX OPENING COVER

Hide 89111 6.REMOVE NETWORK GATEWAY ECU

a.
E339048C01
0,0 0,0 false
V100155

Protective Tape


Using a screwdriver, insert it to the ECU integration box RH and detach the 2 claws.

HINT:

Tape the screwdriver tip before use.



b.

Pull out and remove the network gateway ECU from the ECU integration box RH.