Home › Power Source / Network › NETWORKING › NETWORK GATEWAY ECU(for LHD) › from 2015.10
RM3090E _57 Power Source / Network _008434 NETWORKING _0227728 NETWORK GATEWAY ECU(for LHD) A

NETWORKING  NETWORK GATEWAY ECU(for LHD)  INSTALLATION  


PROCEDURE

Hide 89111 1.INSTALL NETWORK GATEWAY ECU

a.
E332645

Insert the network gateway ECU to the ECU integration box RH.


b.

Push in the network gateway ECU to attach the 2 claws.


Hide 82877 2.INSTALL ECU INTEGRATION BOX RH

a.

Install the ECU integration box RH with the 2 nuts and bolt.


b.

Connect each connector and attach the wire harness clamp.


Hide 55550 3.INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

Hide 55607 4.INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 5.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION