Home › Steering › STEERING COLUMN › STEERING PAD SWITCH › from 2015.10
RM3090E _55 Steering _008773 STEERING COLUMN _0049532 STEERING PAD SWITCH A

STEERING COLUMN  STEERING PAD SWITCH  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS. Read the precautionary notices concerning the SRS before servicing.

w/ Occupant Classification System: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/ Occupant Classification System)>PRECAUTION

w/o Occupant Classification System: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM(w/o Occupant Classification System)>PRECAUTION


HINT:
·

Use the same procedure for RHD and LHD vehicles.


·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 84250A 4.REMOVE STEERING PAD SWITCH ASSEMBLY

a.
C348611

Disconnect the connector from the spiral cable.

HINT:

If the vehicle is equipped with a cruise control switch and shift paddle switch, disconnect their connectors and connector clamps.



b.
C348612

Remove the 2 screws.


c.

Detach the 2 pins and 6 claws and remove the switch assembly.