Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM › from 2016.08
RM3090E _56 Audio / Visual / Telematics _057499 TELEMATICS _0279690 TELEMATICS SYSTEM C

TELEMATICS  TELEMATICS SYSTEM  B1583  GPS Signal Unreceived  


DESCRIPTION

This DTC is stored when GNSS satellite signals is not received for 30 km.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1583 GPS Signal Unreceived GNSS signals are not received for 30 km.
·

Telematics Transceiver

·

Antenna divider

·

No. 1 amplifier antenna assembly

·

No. 3 antenna cord sub-assembly

·

Harness or connector



WIRING DIAGRAM

E355984E01
0.198,2.104 1.656,2.531 1.458,0.427 10 false No. 1 Amplifier Antenna Assembly 1.708,1.083 1.865,1.281 0.156,0.198 10 false A 1.708,1.729 1.865,1.927 0.156,0.198 10 false A 2.969,1.083 3.302,1.333 0.333,0.25 10 false M44 2.979,1.719 3.313,1.969 0.333,0.25 10 false M44 4.063,2.302 5.146,2.646 1.083,0.344 10 false Antenna Divider 4.052,2.135 4.385,2.385 0.333,0.25 10 false M41 1.823,2.125 3.042,2.552 1.219,0.427 10 false No. 3 Antenna Cord Sub-assembly 5.615,2.302 7,2.542 1.385,0.24 10 false Telematics transceiver 5.604,2.135 5.938,2.385 0.333,0.25 10 false M43 5.792,1.083 6.198,1.344 0.406,0.26 10 false ANT2 1.719,0.906 1.875,1.104 0.156,0.198 10 false 5 1.698,1.542 1.896,1.76 0.198,0.219 10 false 5a 3.063,0.906 3.219,1.104 0.156,0.198 10 false 1 3.021,1.542 3.208,1.771 0.188,0.229 10 false 1a 3.906,1 4.063,1.198 0.156,0.198 10 false 6 3.865,1.635 4.052,1.865 0.188,0.229 10 false 6a 5.073,0.99 5.229,1.188 0.156,0.198 10 false 5 5.063,1.625 5.25,1.854 0.188,0.229 10 false 5a 5.583,0.99 5.74,1.188 0.156,0.198 10 false 1 5.542,1.625 5.729,1.854 0.188,0.229 10 false 1a

CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Registration for Telematics System.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM>REGISTRATION


PROCEDURE

1.MOVE VEHICLE
a.

If the vehicle is outside the communication service area, move the vehicle into a communication service area, wait for a while and perform the operation again.


Result:
Proceed to
NEXT



NEXT

2.CHECK DTC
2.CHECK DTC
a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON and wait for 20 seconds.


d.

Turn the GTS on.


e.

Check for DTCs and check that no DTCs are output.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM>DTC CHECK / CLEAR

Body Electrical > Telematics > Trouble Codes
50001 233
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

NG

3.CHECK OPTIONAL COMPONENTS
3.CHECK OPTIONAL COMPONENTS
a.

Check if any optional components that may decrease reception capacity, such as sunshade film or a telephone antenna, are installed.

Result:
Result Proceed to
Optional components are not installed A
Optional components are installed B


NOTICE:

Do not remove optional components without the permission of the customer.




A

4.CHECK DTC OUTPUT

B

REMOVE OPTIONAL COMPONENTS AND CHECK AGAIN (SEE NOTICE ABOVE)

4.CHECK DTC OUTPUT
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM>DTC CHECK / CLEAR

Body Electrical > Navigation System > Clear DTCs
50002 212

b.

Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Navigation System > Trouble Codes
50001 212

Result:
Result Proceed to
No DTCs are output. A
DTC B1583 is output. B



A

END

B

5.INSPECT NO. 3 ANTENNA CORD SUB-ASSEMBLY
5.INSPECT NO. 3 ANTENNA CORD SUB-ASSEMBLY

OK

6.CHECK HARNESS AND CONNECTOR (NO. 3 ANTENNA CORD SUB-ASSEMBLY - ANTENNA DIVIDER)

NG

6.CHECK HARNESS AND CONNECTOR (NO. 3 ANTENNA CORD SUB-ASSEMBLY - ANTENNA DIVIDER)

OK

7.INSPECT ANTENNA DIVIDER

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

7.INSPECT ANTENNA DIVIDER

OK

8.CHECK HARNESS AND CONNECTOR (ANTENNA DIVIDER - TELEMATICS TRANSCEIVER)

NG

8.CHECK HARNESS AND CONNECTOR (ANTENNA DIVIDER - TELEMATICS TRANSCEIVER)

OK

9.CHECK NO. 1 AMPLIFIER ANTENNA ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

9.CHECK NO. 1 AMPLIFIER ANTENNA ASSEMBLY
a.

Replace the No. 1 amplifier antenna assembly with a new or known good one.

Click hereAudio / Visual / Telematics>AUDIO / VIDEO>AMPLIFIER ANTENNA>REMOVAL


b.

Clear the DTCs.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM>DTC CHECK / CLEAR

Body Electrical > Telematics > Clear DTCs
50002 233

c.

Recheck for DTCs and check that no DTCs are output.

Body Electrical > Telematics > Trouble Codes
50001 233
OK:

No DTCs are output.



Result:
Proceed to
OK
NG



OK

END (NO. 1 AMPLIFIER ANTENNA ASSEMBLY IS DEFECTIVE)

NG

10.REPLACE TELEMATICS TRANSCEIVER
10.REPLACE TELEMATICS TRANSCEIVER
a.

Replace the telematics transceiver with a new one.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL


Result:
Proceed to
NEXT



NEXT