This DTC is stored when a malfunction occurs in the speakers.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15C3 | Speaker Output Short | A short is detected in the speaker output circuit. | ·
Harness or connector ·
Speakers ·
Radio and display receiver assembly ·
Telematics transceiver* |
*: w/ Telematics Transceiver
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Clear the DTCs.
Check for DTCs.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Choose the model to be inspected.
| Result | Proceed to |
|---|---|
| w/o Telematics Transceiver | A |
| w/ Telematics Transceiver | B |
A
B
*1: for LH Side
*2: for RH Side
Disconnect the G141 and G142 radio and display receiver assembly connectors.
Disconnect the J1*1 and/or I1*2 front No. 1 speaker assembly connector.
Disconnect the H1*1 and/or H3*2 front No. 2 speaker assembly connector.
Disconnect the L2*1 and/or K2*2 rear speaker assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G141-2 (FL+) - H1-4 (TWL+) | Always | Below 1 Ω |
| G141-6 (FL-) - H1-2 (TWL-) | Always | Below 1 Ω |
| H1-3 (+) - J1-1 | Always | Below 1 Ω |
| H1-1 (-) - J1-2 | Always | Below 1 Ω |
| G142-2 (RL+) - L2-1 | Always | Below 1 Ω |
| G142-6 (RL-) - L2-2 | Always | Below 1 Ω |
| G141-2 (FL+) - Body ground | Always | 10 kΩ or higher |
| G141-6 (FL-) - Body ground | Always | 10 kΩ or higher |
| G142-2 (RL+) - Body ground | Always | 10 kΩ or higher |
| G142-6 (RL-) - Body ground | Always | 10 kΩ or higher |
| H1-3 (+) - Body ground | Always | 10 kΩ or higher |
| H1-1 (-) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G141-1 (FR+) - H3-4 (TWR+) | Always | Below 1 Ω |
| G141-5 (FR-) - H3-2 (TWR-) | Always | Below 1 Ω |
| H3-3 (+) - I1-1 | Always | Below 1 Ω |
| H3-1 (-) - I1-2 | Always | Below 1 Ω |
| G142-1 (RR+) - K2-1 | Always | Below 1 Ω |
| G142-3 (RR-) - K2-2 | Always | Below 1 Ω |
| G141-1 (FR+) - Body ground | Always | 10 kΩ or higher |
| G141-5 (FR-) - Body ground | Always | 10 kΩ or higher |
| G142-1 (RR+) - Body ground | Always | 10 kΩ or higher |
| G142-3 (RR-) - Body ground | Always | 10 kΩ or higher |
| H3-3 (+) - Body ground | Always | 10 kΩ or higher |
| H3-1 (-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL
Inspect the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the rear speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>REMOVAL
Inspect the rear speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the front No. 2 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>REMOVAL
Clear the DTCs.
Check for DTCs.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
*1: for LH Side
*2: for RH Side
Disconnect the G141 and G142 radio and display receiver assembly connectors.
Disconnect the J1*1 and/or I1*2 front No. 1 speaker assembly connector.
Disconnect the H1*1 and/or H3*2 front No. 2 speaker assembly connector.
Disconnect the L2*1 and/or K2*2 rear speaker assembly connector.
Disconnect the M38 telematics transceiver connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G141-2 (FL+) - H1-4 (TWL+) | Always | Below 1 Ω |
| G141-6 (FL-) - H1-2 (TWL-) | Always | Below 1 Ω |
| H1-3 (+) - J1-1 | Always | Below 1 Ω |
| H1-1 (-) - J1-2 | Always | Below 1 Ω |
| G142-2 (RL+) - L2-1 | Always | Below 1 Ω |
| G142-6 (RL-) - L2-2 | Always | Below 1 Ω |
| G141-2 (FL+) - Body ground | Always | 10 kΩ or higher |
| G141-6 (FL-) - Body ground | Always | 10 kΩ or higher |
| G142-2 (RL+) - Body ground | Always | 10 kΩ or higher |
| G142-6 (RL-) - Body ground | Always | 10 kΩ or higher |
| H1-3 (+) - Body ground | Always | 10 kΩ or higher |
| H1-1 (-) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G141-1 (FR+) - H3-4 (TWR+) | Always | Below 1 Ω |
| G141-5 (FR-) - H3-2 (TWR-) | Always | Below 1 Ω |
| H3-3 (+) - M38-2 (SPI+) | Always | Below 1 Ω |
| H3-1 (-) - M38-3 (SPI-) | Always | Below 1 Ω |
| M38-5 (SPO+) - I1-1 | Always | Below 1 Ω |
| M38-6 (SPO-) - I1-2 | Always | Below 1 Ω |
| G142-1 (RR+) - K2-1 | Always | Below 1 Ω |
| G142-3 (RR-) - K2-2 | Always | Below 1 Ω |
| G141-1 (FR+) - Body ground | Always | 10 kΩ or higher |
| G141-5 (FR-) - Body ground | Always | 10 kΩ or higher |
| H3-3 (+) - Body ground | Always | 10 kΩ or higher |
| H3-1 (-) - Body ground | Always | 10 kΩ or higher |
| M38-5 (SPO+) - Body ground | Always | 10 kΩ or higher |
| M38-6 (SPO-) - Body ground | Always | 10 kΩ or higher |
| G142-1 (RR+) - Body ground | Always | 10 kΩ or higher |
| G142-3 (RR-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL
Inspect the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the rear speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>REMOVAL
Inspect the rear speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the front No. 2 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>REMOVAL
Clear the DTCs.
Check for DTCs.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the telematics transceiver with a new one.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL
Clear the DTCs.
Check for DTCs.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG