Home › Engine / Hybrid System › 3ZR-FAE INTAKE / EXHAUST › INTAKE MANIFOLD › from 2015.04
RM3090E _51 Engine / Hybrid System _008390 3ZR-FAE INTAKE / EXHAUST _0046831 INTAKE MANIFOLD A

3ZR-FAE INTAKE / EXHAUST  INTAKE MANIFOLD  REMOVAL  


PROCEDURE

Hide 27020 1.REMOVE GENERATOR ASSEMBLY

Hide 22210 3.REMOVE THROTTLE BODY ASSEMBLY

Hide 4.REMOVE VACUUM SENSOR ASSEMBLY

A173115

a.

Disconnect the vacuum sensor assembly connector.


b.

Remove the engine cover joint and vacuum sensor assembly.


c.

Disconnect the No. 1 air hose from the vacuum sensor assembly.


Hide 25860 5.REMOVE VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)

A173105

a.

Disconnect the vacuum switching valve assembly connector.


b.

Disconnect the vacuum hose and No. 2 air hose.


c.

Remove the bolt and vacuum switching valve assembly.


Hide 17111 6.REMOVE INTAKE MANIFOLD

a.
A207744

Remove the bolt and wire harness clamp bracket.


b.

Detach the 4 clamps and wire harness from the intake manifold.


c.
A293766

Disconnect the fuel vapor feed hose from the intake manifold.


d.

Slide the clamp and disconnect the PCV hose from the intake manifold.


e.
A204422

Remove the 5 bolts, 2 nuts, intake manifold stay and intake manifold.


f.
A173120

Remove the gasket from the intake manifold.


g.
A207746

Remove the bolt and wire harness clamp bracket from the intake manifold.


h.

with Stud Bolt:

Using an E6 "TORX" socket wrench, remove the 2 stud bolts from the intake manifold.


Hide 23265 7.REMOVE NO. 1 GAS FILTER

A293783

a.

Remove the No. 1 air hose from the No. 1 gas filter and intake manifold.


b.

Using a 24 mm deep socket wrench, remove the No. 1 gas filter from the intake manifold.


Hide 12635 8.REMOVE ENGINE COVER JOINT

a.
A216085

Remove the engine cover joint.