Home › Power Source / Network › 3ZR-FAE BATTERY / CHARGING › GENERATOR › 2015.04–2015.10
RM3090E _57 Power Source / Network _008394 3ZR-FAE BATTERY / CHARGING _0046853 GENERATOR A

3ZR-FAE BATTERY / CHARGING  GENERATOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 51441 3.REMOVE NO. 1 ENGINE UNDER COVER

Hide 51443 4.REMOVE REAR ENGINE UNDER COVER RH

Hide 11212 5.REMOVE NO. 2 CYLINDER HEAD COVER

Hide 27020 7.REMOVE GENERATOR ASSEMBLY

a.
A348598

Remove the terminal cap.


b.

Remove the nut and disconnect the wire harness from terminal B.


c.

Disconnect the connector and detach the wire harness clamp.


d.
A348599

Remove the 3 bolts, No. 2 generator bracket and generator assembly.


e.
A285298

Remove the bolt and wire harness clamp bracket.