31321
1.INSTALL CLUTCH PEDAL PAD
Install the clutch pedal pad to the clutch pedal sub-assembly.
31301P
2.INSTALL CLUTCH PEDAL TURNOVER BUSH
|
MP Grease |
Apply MP grease to the contact surface of the clutch pedal turnover bush.
Install the clutch pedal turnover bush.
31324A
3.INSTALL CLUTCH PEDAL SHAFT COLLAR
|
MP Grease |
Apply MP grease to both sides of the clutch pedal shaft collar and 2 new bushes.
Install the clutch pedal shaft collar.
Install the 2 bushes.
31301A
4.INSTALL CLUTCH PEDAL SPRING HOLDER
|
MP Grease |
Apply MP grease to the contact surface of the clutch pedal spring holder.
Install the clutch pedal spring holder.
31301
5.INSTALL CLUTCH PEDAL SUB-ASSEMBLY
Install the clutch pedal to the clutch pedal support with the bolt and nut.
Install the bolt from the left side of the vehicle.
31301A
6.INSTALL CLUTCH PEDAL SPRING
|
MP Grease |
Apply MP grease to the contact surface of the clutch pedal sub-assembly.
Install the pedal with hook spring.
88280A
7.INSTALL CLUTCH START SWITCH ASSEMBLY
Install the clutch start switch assembly with the nut.
89280
8.INSTALL CLUTCH PEDAL STROKE SENSOR ASSEMBLY
55107A
9.INSTALL CLUTCH PEDAL SUPPORT SUB-ASSEMBLY
Install the clutch pedal support sub-assembly.
Install the 4 nuts.
Check that the push rod cannot be turned 30° or more in order to confirm that the clevis is securely engaged in the pedal.
Connect the 2 connectors and 2 clamps.
31453A
10.INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS WITH HOLE PIN
|
MP Grease |
Apply MP grease to the contact surface of the clutch master cylinder push rod clevis with hole pin.
Connect the clevis to the clutch pedal assembly with the clutch master cylinder push rod clevis with hole pin.
Install the clutch master cylinder push rod clevis with hole pin from the left side of the vehicle.
Install a new clip to the clutch master cylinder push rod clevis with hole pin.
88280A
11.INSPECT CLUTCH START SWITCH ASSEMBLY
89280
12.INSPECT CLUTCH PEDAL STROKE SENSOR ASSEMBLY
31301
13.INSPECT CLUTCH PEDAL SUB-ASSEMBLY
14.INSTALL KNEE AIRBAG ASSEMBLY (for Driver Side)