67913B
1.REMOVE FRONT DOOR SCUFF PLATE RH
62111C
2.REMOVE COWL SIDE TRIM BOARD RH
55606
3.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
4.INSPECT CLUTCH PEDAL HEIGHT
Fold back the floor carpet.
Check that the clutch pedal height is correct.
| *1 | Clutch Pedal Pad | - | - |
| *a | Clutch Pedal Height | *b | Measuring Plane of Floor Panel |
| *c | 30 mm (1.18 in.) | - | - |
199.6 to 217.6 mm (7.86 to 8.56 in.)
If the result is not as specified, bleed the clutch line and perform the inspection again.
If the result is not as specified after bleeding the clutch line, replace the clutch master cylinder assembly.
Install the floor carpet.
5.INSPECT CLUTCH PEDAL FREE PLAY
| *a | Pedal Free Play |
Check that the clutch pedal free play is correct.
Pay close attention to the change in resistance to distinguish clutch pedal free play while performing the inspection.
Depress the clutch pedal until clutch resistance begins to be felt.
3 to 15 mm (0.118 to 0.591 in.)
If the result is not as specified, bleed the clutch line and perform the inspection again.
If the result is not as specified after bleeding the clutch line, replace the clutch master cylinder assembly.
6.INSPECT CLUTCH RELEASE POINT
When checking the clutch release point, ensure that the vehicle is secure.
| *a | Release Point |
| *b | Full Stroke End Position |
| *c | Distance from Clutch Pedal Stroke End Position to Release Point |
| *d | Clutch Pedal Stroke |
Check the clutch release point.
Be sure to apply the parking brake and secure the wheels using wheel chocks.
Start the engine and run it at idle.
Without depressing the clutch pedal, slowly move the shift lever to reverse until the gears contact.
Gradually depress the clutch pedal and measure the stroke distance from the point that the gear noise stops (release point) up to the full stroke end position.
25 mm (0.984 in.) or more (from clutch pedal stroke end position to release point)
146 to 156 mm (5.75 to 6.14 in.)
If the distance is not as specified, perform the following procedure:
Check the clutch pedal height.
Check the clutch pedal free play.
Bleed the clutch line.
Check the clutch cover and the clutch disc.
89280
7.ADJUST CLUTCH PEDAL STROKE SENSOR ASSEMBLY
55606
8.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
62111C
9.INSTALL COWL SIDE TRIM BOARD RH
67913B
10.INSTALL FRONT DOOR SCUFF PLATE RH