Home › Engine / Hybrid System › CRUISE CONTROL › CRUISE CONTROL SYSTEM (for HV Model)
RM3620E _51 Engine / Hybrid System _076038 CRUISE CONTROL _0370336 CRUISE CONTROL SYSTEM(for HV Model) J

CRUISE CONTROL  CRUISE CONTROL SYSTEM(for HV Model)  Cruise SET Indicator Light Circuit  


DESCRIPTION

The hybrid vehicle control ECU assembly illuminates the cruise control SET indicator by sending indicator output demand signals to the combination meter assembly via CAN communication. The cruise control SET indicator illuminates when the cruise control system is controlling vehicle speed. The cruise SET indicator light circuit uses CAN communication. If the cruise control SET indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit.

CAUTION / NOTICE / HINT

CAUTION:

Observe the following items for safety reasons when using the GTS:

·
A356952

Before using the GTS, read the instruction manual.

·
A356953

Prevent the GTS cable from being caught on the pedals, shift lever or steering wheel when driving with the GTS connected to the vehicle.

·

When driving the vehicle for testing purposes, 2 people are required. One person should operate the GTS while the other drives the vehicle.



NOTICE:
·

Before replacing the hybrid vehicle control ECU assembly refer to Service Bulletin.

·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.



PROCEDURE

1.PERFORM ACTIVE TEST USING GTS
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Combination Meter / Active Test.


e.

Perform the Active Test according to the display on the GTS.

Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM (for HV Model)>DATA LIST / ACTIVE TEST

Body Electrical > Combination Meter > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Multi Display All (White) Multi-information display (White display) ON -
Body Electrical > Combination Meter > Active Test
Tester Display
Multi Display All (White)
50004 409 20

Result:
Result Proceed to
The multi-information display in the combination meter assembly turns on according to the operation of the Active Test. A
The multi-information display in the combination meter assembly does not turn on according to the operation of the Active Test. B



A

2.READ VALUE USING GTS

B

2.READ VALUE USING GTS
a.

Turn the cruise control system on using the cruise control main switch.


b.

Drive at a speed between approximately 30 km/h (20 mph) or higher.


c.

Enter the following menus: Powertrain / Cruise Control / Data List.


d.

Read the Data List according to the display on the GTS.

Click hereEngine / Hybrid System>CRUISE CONTROL>CRUISE CONTROL SYSTEM (for HV Model)>DATA LIST / ACTIVE TEST

Powertrain > Cruise Control > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
-SET Switch -SET switch status ON or OFF ON: -SET switch pushed
OFF: -SET switch not pushed
-
Powertrain > Cruise Control > Data List
Tester Display
-SET Switch
50003 399 22

Result:
Result Proceed to
The cruise control SET indicator illuminates and turns off according to the operation of the -SET switch. A
The cruise control SET indicator does not illuminate but the Data List item -SET Switch changes according to the operation of the -SET switch. B
The cruise control SET indicator does not illuminate and the Data List item -SET Switch does not change according to the operation of the -SET switch. C



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPLACE COMBINATION METER ASSEMBLY

C

REPLACE HYBRID VEHICLE CONTROL ECU ASSEMBLY