The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during hybrid vehicle control ECU assembly removal/installation are shown below.
After the power switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the power switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
1. PRECAUTION
Be sure to read precaution thoroughly before servicing.
w/o Occupant Classification System:
for HV Model with Occupant Classification System:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
58410B
2.REMOVE DECK BOARD ASSEMBLY
58416K
3.REMOVE REAR NO. 2 FLOOR BOARD
65351A
4.REMOVE BATTERY HOLE COVER
5.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>A25A-FXS AUXILIARY BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
73900
6.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for LHD)
58810J
7.REMOVE CONSOLE BOX ASSEMBLY (for RHD)
67914B
8.REMOVE FRONT DOOR SCUFF PLATE LH (for RHD)
62112
9.REMOVE COWL SIDE TRIM BOARD LH (for RHD)
Use the same procedure described for the RH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL
55607
10.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)
55550
11.REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for RHD)
55433B
12.REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL (for RHD)
89981
13.REMOVE HYBRID VEHICLE CONTROL ECU ASSEMBLY (for LHD)
Disconnect the connector.
w/ VEHICLE APPROACHING SPEAKER CONTROLLER:
Disconnect the connector.
Disengage the clamp.
Disconnect the 3 hybrid vehicle control ECU assembly connectors as shown in the illustration.
Remove the 2 nuts and hybrid vehicle control ECU assembly.
89981
14.REMOVE HYBRID VEHICLE CONTROL ECU ASSEMBLY (for RHD)
Disengage the 2 clamps.
Disconnect the 4 connectors.
Disconnect the 5 connectors.
Disconnect the 3 hybrid vehicle control ECU assembly connectors as shown in the illustration.
|
Bolt |
|
Nut |
Remove the bolt, nut and hybrid vehicle control ECU assembly.
86572
15.REMOVE VEHICLE APPROACHING SPEAKER CONTROLLER (for LHD, w/ VEHICLE APPROACHING SPEAKER CONTROLLER)