The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during steering knuckle removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
1.REMOVE FRONT AXLE ASSEMBLY LH
43340A
2.REMOVE FRONT LOWER BALL JOINT ASSEMBLY LH
for Steel Steering Knuckle: Click hereSuspension>FRONT SUSPENSION>FRONT LOWER BALL JOINT>REMOVAL
for Aluminum Steering Knuckle: Click hereSuspension>FRONT SUSPENSION>FRONT LOWER BALL JOINT>REMOVAL
43212
3.REMOVE STEERING KNUCKLE LH
Secure the front axle assembly between aluminum plates in a vise.
Do not overtighten the vise.
Remove the 4 bolts, front axle hub sub-assembly and front disc brake dust cover from the steering knuckle.
Do not drop the front axle hub sub-assembly.
Be careful not to damage the speed sensor rotor or contact surfaces.
Do not allow foreign matter to contact the speed sensor rotor or contact surfaces.