The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front axle hub assembly removal/installation are shown below.
After the ignition switch is turned off, the navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) auxiliary battery terminal.
Use the same procedure for the RH and LH sides.
The following procedure is for the LH side.
1.DISABLE BRAKE CONTROL (w/o Vacuum Brake Booster)
Click hereBrake>BRAKE (REAR)>REAR BRAKE>REMOVAL
2.REMOVE FRONT WHEEL
43502H
3.REMOVE FRONT AXLE SHAFT NUT LH
Using SST and a hammer, unstake the staked part of the front axle shaft nut.
Loosen the staked part of the front axle shaft nut completely, otherwise the screw of the drive shaft may be damaged.
While applying the brakes, remove the front axle shaft nut.
89543
4.DISCONNECT FRONT SPEED SENSOR LH
Remove the bolt and disconnect the front speed sensor and front flexible hose from the front shock absorber assembly.
Be sure to separate the front speed sensor and front flexible hose from the front shock absorber assembly completely.
Remove the bolt, disengage the clamp and disconnect the front speed sensor from the front shock absorber assembly and steering knuckle.
Prevent foreign matter from contacting the sensor tip.
Be careful not to damage the front speed sensor.
Clean the speed sensor installation hole and the contact surfaces every time the front speed sensor is removed.
45470
5.DISCONNECT TIE ROD ASSEMBLY LH
6.DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH
43512
7.REMOVE FRONT DISC
for 2-Pot Caliper: Click hereBrake>BRAKE (FRONT)>FRONT BRAKE (for 2-Pot Caliper)>REMOVAL
except 2-Pot Caliper: Click hereBrake>BRAKE (FRONT)>FRONT BRAKE (except 2-Pot Caliper)>REMOVAL
48069
8.DISCONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH
Remove the bolt and 2 nuts and disconnect the front lower No. 1 suspension arm sub-assembly from the front lower ball joint assembly.
43420
9.DISCONNECT FRONT DRIVE SHAFT ASSEMBLY LH
| *a | Matchmark |
Place matchmarks on the front axle hub LH and front drive shaft assembly LH as shown in the illustration.
Using a plastic hammer, disconnect the front drive shaft assembly from the front axle assembly.
Do not damage the front drive shaft outboard joint boot.
Do not push the front axle assembly towards the outside of the vehicle any further than necessary.
If it is difficult to separate the front drive shaft assembly from the front axle assembly, tap the end of the front drive shaft assembly using a brass bar and a hammer.
10.REMOVE FRONT AXLE ASSEMBLY LH
Remove the 2 bolts, 2 nuts and front axle assembly from the front shock absorber assembly.
When removing the nuts, keep the bolts from rotating.
43502C
11.REMOVE FRONT AXLE HUB SUB-ASSEMBLY LH
Secure the front axle assembly between aluminum plates in a vise.
Do not overtighten the vise.
Remove the 4 bolts, front axle hub sub-assembly and front disc brake dust cover from the steering knuckle.
Do not drop the front axle hub sub-assembly.
Be careful not to damage the speed sensor rotor or contact surfaces.
Do not allow foreign matter to contact the speed sensor rotor or contact surfaces.