The air conditioning control assembly communicates with the air conditioning amplifier assembly via LIN communication.
If the LIN communication system malfunctions, the air conditioning amplifier assembly does not operate even if the air conditioning control assembly is operated.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory |
|---|---|---|---|---|
| B14B2 | Lost Communication with Front Panel LIN | Lost communication with air conditioning control assembly
·
Diagnosis condition: Ignition switch ON ·
Malfunction status: Lost communication with air conditioning control assembly ·
Detection time: Continuously for 10 seconds or more |
·
Harness or connector ·
Air conditioning control assembly ·
Air conditioning amplifier assembly |
Memorized |
Inspect the fuses for circuits related to this system before performing the following procedure.
| *a | Front view of wire harness connector
(to Air Conditioning Control Assembly) |
Disconnect the air conditioning control assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G24-13 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G24-9 (IG+) - Body ground | Ignition switch ON | 10.5 to 16 V |
| Ignition switch off | Below 1 V |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G24-9 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V |
| Result | Proceed to |
|---|---|
| OK | A |
| NG (w/ Stop and Start System) | B |
| NG (w/o Stop and Start System) | C |
A
B
C
Disconnect the G24 air conditioning amplifier assembly connector.
Disconnect the G46 air conditioning control assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G24-7 (LIN1) - G46-7 (LIN1) | Always | Below 1 Ω |
| G24-7 (LIN1) or G46-7 (LIN1) - Other terminals and body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component with harness connected
(Air Conditioning Amplifier Assembly) |
Using an oscilloscope, check the waveform.
| Item | Content |
|---|---|
| Tester Connection | G46-7 (LIN1) - Body ground |
| Tool Setting | 2 V/DIV., 20 ms/DIV. |
| Condition | Ignition switch ON |
The waveform displays properly.
| Proceed to |
|---|
| OK |
| NG |
OK
NG