If the air conditioning system does not operate even when the air conditioning control assembly is operated, the following causes are possible.
| Malfunction Status | Factor |
|---|---|
| Operations are never accepted by the integration control and panel assembly
(With the exception of the switch indicator, everything is turned off) |
·
LIN communication malfunction between air conditioning amplifier assembly and air conditioning control assembly ·
Air conditioning amplifier assembly malfunction (+B or GND circuit) ·
Air conditioning control assembly malfunction |
Inspect the fuses for circuits related to this system before performing the following procedure.
If DTC B14B7 is output at the same time, troubleshoot for DTC B14B7 first.
Check for DTCs.
DTC B14B2 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM (for Gasoline Model)>B14B2
| *a | Front view of wire harness connector
(to Air Conditioning Amplifier Assembly) |
Disconnect the air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G46-17 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G46-5 (B) - Body ground | Always | 11 to 14 V |
| G46-6 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG