Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM3620E _56 Audio / Visual / Telematics _076129 PARK ASSIST / MONITORING _0370833 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1AB8  Destination Information Undefined  


DESCRIPTION

This DTC is stored when correct destination information is not sent from the main body ECU (multiplex network body ECU) and destination information cannot be confirmed after a blind spot monitor sensor has been replaced.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1AB8 Destination Information Undefined The blind spot monitor sensor cannot communicate with the main body ECU
·

CAN communication system

·

Main body ECU (multiplex network body ECU)

·

Blind spot monitor sensor RH

·

Blind spot monitor sensor LH



CAUTION / NOTICE / HINT

NOTICE:
·

When checking for DTCs, make sure that the blind spot monitor system is turned on.

·

Before replacing the main body ECU (multiplex network body ECU), refer to the Service Bulletin.



PROCEDURE

1.CHECK DTC
a.

Check for CAN communication system DTCs.

for Gasoline Model

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for Gasoline Model)>DIAGNOSIS SYSTEM

for HV Model

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for HV Model)>DIAGNOSIS SYSTEM

OK:

CAN communication system DTCs are not output.



Result:
Proceed to
OK
NG



OK

2.REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

2.REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
a.

Replace the main body ECU (multiplex network body ECU) with a new one.

for LHD

Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for LHD)>REMOVAL

for RHD

Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for RHD)>REMOVAL


Result:
Proceed to
NEXT



NEXT

3.RECHECK DTC
3.RECHECK DTC
a.

Recheck for DTCs and check if the same DTC is output again.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR

Body Electrical > Blind Spot Monitor Master > Trouble Codes
50001 313
Body Electrical > Blind Spot Monitor Slave > Trouble Codes
50001 314

Result:
Result Proceed to
No DTCs are output. A
DTC C1AB8 is output ("Blind Spot Monitor Master"). B
DTC C1AB8 is output ("Blind Spot Monitor Slave"). C



A

END (MAIN BODY ECU [MULTIPLEX NETWORK BODY ECU] WAS DEFECTIVE)

B

C