Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM3620E _56 Audio / Visual / Telematics _076129 PARK ASSIST / MONITORING _0370833 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  U1331  Software Incompatibility with Body Control Module "B"  


DESCRIPTION

This DTC is stored when the destination information of the main body ECU (multiplex network body ECU) does not match that of the blind spot monitor sensors.

DTC No. Detection Item DTC Detection Condition Trouble Area
U1331 Software Incompatibility with Body Control Module "B" Destination information of the main body ECU and blind spot monitor sensor do not match
·

Main body ECU (multiplex network body ECU)

·

Blind spot monitor sensor RH

·

Blind spot monitor sensor LH



CAUTION / NOTICE / HINT

NOTICE:
·

When checking for DTCs, make sure that the blind spot monitor system is turned on.

·

Before replacing the main body ECU (multiplex network body ECU), refer to the Service Bulletin.



PROCEDURE

1.CONFIRM PART NUMBER (MAIN BODY ECU [MULTIPLEX NETWORK BODY ECU])
a.

Check the main body ECU (multiplex network body ECU) part number.

i.

Check if the part number of the main body ECU (multiplex network body ECU) installed to the vehicle is correct.

OK:

The part number is correct.




Result:
Proceed to
OK
NG



OK

2.CHECK DTC

NG

2.CHECK DTC
a.

Turn the ignition switch off.


b.

Turn the ignition switch to ON.


c.

Recheck for DTCs and check if the same DTC is output again.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR

Body Electrical > Blind Spot Monitor Master > Trouble Codes
50001 313
Body Electrical > Blind Spot Monitor Slave > Trouble Codes
50001 314

Result:
Result Proceed to
No DTCs are output. A
DTC U1331 is output ("Blind Spot Monitor Master"). B
DTC U1331 is output ("Blind Spot Monitor Slave"). C



A

B

C