| Detection Item | Symptom | Trouble Area |
|---|---|---|
| Bus Buffer ECU Communication Stop Mode | Any of the following conditions are met:
·
·
|
·
Option connector (bus buffer ECU) branch wire or connector ·
Option connector (bus buffer ECU) |
When performing the confirmation driving pattern, obey all speed limits and traffic laws.
Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output.
Before measuring the resistance of the CAN bus, turn the ignition switch off and leave the vehicle for 1 minute or more without operating the key or any switches, or opening or closing the doors. After that, disconnect the cable from the negative (-) battery terminal and leave the vehicle for 1 minute or more before measuring the resistance.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
Some parts must be initialized and set when replacing or removing and installing parts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
After performing repairs, perform the DTC check procedure and confirm that the DTCs are not output again.
DTC check procedure: Turn the ignition switch to ON and wait for 1 minute or more. Then operate the suspected malfunctioning system and drive the vehicle at 60 km/h (37 mph) or more for 5 minutes or more.
After the repair, perform the CAN bus check and check that all the ECUs and sensors connected to the CAN communication system are displayed.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for Gasoline Model)>DIAGNOSIS SYSTEM
Before disconnecting related connectors for inspection, push in on each connector body to check that the connector is not loose or disconnected.
When a connector is disconnected, check that the terminals and connector body are not cracked, deformed or corroded.
Check whether dealer installed options that support CAN communication are installed.
| Result | Proceed to |
|---|---|
| Installed | A |
| Not installed | B |
A
B
Disconnect the cable from the negative (-) battery terminal.
| *a | Front view of wire harness connector
(to Option Connector [Bus Buffer ECU]) |
Disconnect the option connector (bus buffer ECU).*
*: When a dealer-installed option is installed
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G80-2 (CAN+) - G80-1 (CAN-) | Cable disconnected from negative (-) battery terminal | 54 to 69 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
*: When a dealer-installed option is installed
Turn the GTS on.
Enter the following menus: Body Electrical / Central Gateway / Utility / Initialization.
| Tester Display |
|---|
| Initialization |
Enter the following menus: Body Electrical / Main Body / Utility / Initialization.
| Tester Display |
|---|
| Initialization |
Enter the following menus: Body Electrical / Main Body / Clear DTCs.
Enter the following menus: Body Electrical / Main Body / Trouble Codes.
| Result | Proceed to |
|---|---|
| DTC U1117 is not output from main body ECU (multiplex network body ECU) | A |
| DTC U1117 is output from main body ECU (multiplex network body ECU) | B |
A
B
for LHD: Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for LHD)>REMOVAL
for RHD: Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for RHD)>REMOVAL