Home › Drivetrain › P710 (HYBRID TRANSMISSION / TRANSAXLE) › TRANSMISSION CONTROL CABLE › 2018.10–2019.02
RM3620E _52 Drivetrain _076274 P710 HYBRID TRANSMISSION / TRANSAXLE _0371338 TRANSMISSION CONTROL CABLE A

P710 HYBRID TRANSMISSION / TRANSAXLE  TRANSMISSION CONTROL CABLE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission control cable assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Gas leaks from exhaust system Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


w/ Canister Pump Module:(Click here)
w/o Canister Pump Module:(Click here)

PROCEDURE

Hide 1.SECURE VEHICLE

a.

Fully apply the parking brake and chock a wheel.

CAUTION:
C332327

·

Make sure to apply the parking brake and chock a wheel before performing this procedure.

·

If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, possibly resulting in an accident or serious injury.




Hide 12601B 2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY

Hide 17750A 3.REMOVE INLET AIR CLEANER ASSEMBLY

Hide 4.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE

Hide 53896B 5.REMOVE FRONT FENDER FRONT SPLASH SHIELD LH

Hide 53895B 6.REMOVE FRONT FENDER FRONT SPLASH SHIELD RH

Hide 51441 7.REMOVE NO. 1 ENGINE UNDER COVER

Hide 51420 8.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY

Hide 17410 9.REMOVE FRONT EXHAUST PIPE ASSEMBLY

Hide 58810J 10.REMOVE CONSOLE BOX ASSEMBLY

Hide 58861B 11.REMOVE NO. 1 CONSOLE BOX DUCT

Hide 33820B 12.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

Hide 33820B 13.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Move the shift lever to N.


b.
C402988

Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.


c.
C402989

Using a screwdriver, disengage the 4 claws and disconnect the transmission control cable assembly with the clip from the No. 1 transmission control cable bracket.


d.
C377870

Using a screwdriver, disengage the 2 claws and remove the clip from the transmission control cable assembly.


e.
C402990

Remove the 3 bolts and disconnect the transmission control cable assembly from the inverter with converter assembly.


f.
C402992

Remove the nut and disconnect the transmission control cable assembly from the vehicle body.


g.
C402994

Remove the 2 nuts and then remove the transmission control cable assembly from the vehicle body.