Wear protective gloves. Sharp areas on the parts may injure your hands.
There is risk of injury.
Use the same procedure for RHD and LHD vehicles.
The procedure listed below is for LHD vehicles.
85822B
1.INSTALL POWER SEAT TILT MOTOR ASSEMBLY LH
85822C
2.INSTALL POWER SEAT LIFTER MOTOR ASSEMBLY LH
72125T
3.INSTALL FRONT SEAT REAR UPPER TRACK COVER LH
|
Install in this Direction |
Attach the claw and install the front seat rear upper track cover LH.
Use the same procedure for the other side.
72266
4.INSTALL SEAT UPPER TRACK RAIL COVER LH
Use the same procedure for the other side.
w/ Memory:
Connect the No. 4 terminal of the slide motor to the positive (+) auxiliary battery terminal, and the No. 1 terminal to the negative (-) auxiliary battery terminal and then move the front seat adjuster assembly LH to the frontmost position.
After performing this procedure, initialize the seat ECU (position control ECU assembly).
w/o Memory:
Connect the No. 2 terminal of the slide motor to the positive (+) auxiliary battery terminal, and the No. 1 terminal to the negative (-) auxiliary battery terminal and then move the front seat adjuster assembly LH to the frontmost position.
|
Install in this Direction |
Attach the claw and install the seat upper track rail cover LH.
71874C
5.INSTALL FRONT SEAT LOWER CUSHION SHIELD
|
Install in this Direction |
Push in the installation direction shown in the illustration to attach the guide and claw to install the front seat lower cushion shield.
82192
6.INSTALL FRONT SEAT WIRE LH
| *a | Above the front seat cushion wire harness holder LH |
Attach the claw and clamp to install the front seat wire LH.
Attach the claw first.
Pass the wire harness indicated in the illustration above the front seat cushion wire harness holder LH.
8219BA
7.INSTALL FRONT NO. 3 SEAT WIRE LH (w/ Seat Position Airbag Sensor)
Attach the claw and clamp to install the front No. 3 seat wire LH.
87501B
8.INSTALL SEAT HEATER CONTROL SUB-ASSEMBLY LH (w/ Seat Heater System, w/ Climate Control Seat System)
|
Install in this Direction |
Attach the claw and install the seat heater control sub-assembly LH.
Connect the connector.
7181B
9.INSTALL FRONT SEAT CUSHION WIRE HARNESS HOLDER LH
Slide in the installation direction shown in the illustration to attach the hook and claw.
| *a | Hook | *b | Guide |
|
Install in this Direction | - | - |
Attach the guide.
Install the front seat cushion wire harness holder LH with the 2 screws.
Attach the clamp.
Connect the 3 connectors.
w/ Seat Position Airbag Sensor:
Connect the connector.
71052A
10.INSTALL FRONT SEAT CUSHION SPRING SUB-ASSEMBLY LH
| *a | Clamp |
| *b | Hook |
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Attach the hook on the rear side of the front seat cushion spring sub-assembly LH in the installation direction (1) shown in the illustration.
Push in the installation direction (2) shown in the illustration to attach the hook on the front side and install the front seat cushion spring sub-assembly LH.
w/ Seat Heater System:
Attach the clamp.
85860B
11.INSTALL SEAT CUSHION CLIMATE CONTROL BLOWER ASSEMBLY LH (w/ Climate Control Seat System)
Attach the hook and install the seat cushion climate control blower assembly LH.
Install the 2 bolts.
Connect the connector and attach the clamp.
71874A
12.INSTALL FRONT SEAT LOWER CUSHION SHIELD LH
| *a | Hook |
| *b | Guide |
|
Install in this Direction |
Attach the guide as shown in the illustration.
Attach the claw.
Attach the hook to install the front seat lower cushion shield LH.
71873U
13.INSTALL FRONT SEAT LOWER CUSHION SHIELD RH
| *a | Hook |
| *b | Guide |
|
Install in this Direction |
Attach the guide as shown in the illustration.
Attach the claw.
Attach the hook to install the front seat lower cushion shield RH.
71876G
14.INSTALL LH SEAT RECLINING ADJUSTER INSIDE COVER
|
Install in this Direction |
Attach the hook and claw to install the LH seat reclining adjuster inside cover as shown in the illustration.
71875G
15.INSTALL LH SEAT RECLINING ADJUSTER INSIDE COVER
| *a | Guide |
| *b | Hook |
|
Install in this Direction |
Attach the hook, guide and claw to install the LH seat reclining adjuster inside cover as shown in the illustration.
87510L
16.INSTALL FRONT SEAT CUSHION HEATER ASSEMBLY LH (w/ Seat Heater System)
71072S
17.INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER
When installing a separate type front seat cushion cover, refer to Precaution in order to prevent wrinkles from forming.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>PRECAUTION
for Standard Seat Type:
Attach the hook to install the separate type front seat cushion cover to the separate type front seat cushion pad.
Be careful not to dirty or damage the separate type front seat cushion cover.
for Sports Seat Type:
Attach the hook to install the separate type front seat cushion cover to the separate type front seat cushion pad.
Be careful not to dirty or damage the separate type front seat cushion cover.
| *a | Band |
|
Install in this Direction |
Attach the band.
18.INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
Attach the hook and install the separate type front seat cushion cover with pad.
w/ Seat Heater System:
Connect the connector and attach the clamp.
71759D
19.INSTALL FRONT NO. 2 SEATBACK HOOK
Attach the claw and install 2 new front No. 2 seatback hooks.
Check that the claw of the front seatback hooks are securely attached.
71587B
20.INSTALL FRONT SEATBACK EDGE PROTECTOR
Attach the claw and install the 2 front seatback edge protectors.
85867A
21.INSTALL SEATBACK CLIMATE CONTROL BLOWER LH (w/ Climate Control Seat System)
Attach the hook and claw to install the seatback climate control blower LH.
72760D
22.INSTALL LUMBAR SUPPORT ADJUSTER ASSEMBLY LH
|
Install in this Direction |
Install the front seatback felt LH.
|
Install in this Direction |
Set the lumbar support adjuster assembly LH to the front seatback frame assembly LH in the installation direction shown in the illustration.
Attach the clamp.
8219B
23.INSTALL FRONT NO. 2 SEAT WIRE LH
| *A | w/ Climate Control Seat System |
Attach the clamp and install the front No. 2 seat wire LH.
w/o Climate Control Seat System:
Connect the 2 connectors.
w/ Climate Control Seat System:
Connect the 3 connectors.
73920A
24.INSTALL FRONT SEAT AIRBAG ASSEMBLY LH
87510N
25.INSTALL FRONT SEATBACK HEATER ASSEMBLY LH (w/ Seat Heater System)
71074S
26.INSTALL SEPARATE TYPE FRONT SEATBACK COVER
When installing a separate type front seatback cover, refer to Precaution in order to prevent wrinkles from forming.
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>PRECAUTION
for Standard Seat Type:
Attach the hook to install the separate type front seatback cover to the separate type front seatback pad.
Be careful not to dirty or damage the separate type front seatback cover.
for Sports Seat Type:
Attach the hook to install the separate type front seatback cover to the separate type front seatback pad.
Be careful not to dirty or damage the separate type front seatback cover.
27.INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD
Install the separate type front seatback cover with pad.
|
Install in this Direction |
Attach the claw to install the 2 front seat headrest supports as shown in the illustration.
Close the 2 fasteners.
w/ Seat Heater System:
Attach the clamp.
| *a | Outshoot |
Attach the hook.
Be careful not to overlap on the route of the wire harness.
Pass the wire harness through the outside of the outshoot.
28.INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY
Attach the guide to install the separate type front seatback assembly to the separate type front seat cushion assembly.
Temporarily install the separate type front seatback assembly with the 4 bolts.
Tighten the 4 bolts.
Attach the hook.
| *A | w/ Seat Heater System |
Attach the claw.
w/o Seat Heater System:
Connect the connector.
w/ Seat Heater System:
Connect the 2 connectors.
Attach the clamp.
Attach the band.
71862
29.INSTALL FRONT SEAT INNER CUSHION SHIELD LH
|
Install in this Direction |
Attach the claw as shown in the illustration.
|
Install in this Direction |
Attach the claw and guide to install the front seat inner cushion shield LH as shown in the illustration.
84922C
30.INSTALL FRONT POWER SEAT SWITCH LH
84921A
31.INSTALL RECLINING POWER SEAT SWITCH KNOB
|
Install in this Direction |
Attach the claw and install the reclining power seat switch knob.
84921B
32.INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
|
Install in this Direction |
Attach the claw and install the slide and vertical power seat switch knob.
71812D
33.INSTALL FRONT SEAT CUSHION SHIELD LH
Connect the connector.
|
Install in this Direction |
Attach the guide in the installation direction shown in the illustration.
Attach the claw.
|
Install in this Direction |
Attach the guide and claw in the installation direction shown in the illustration.
|
Install in this Direction |
Attach the claw to install the front seat cushion shield LH.
71868N
34.INSTALL FRONT SEAT FRONT CUSHION SHIELD LH
|
Install in this Direction |
Attach the guide and claw in the installation direction shown in the illustration.
|
Install in this Direction |
Attach the guide in the installation direction shown in the illustration.
Install the front seat front cushion shield LH with the clip.
73240
35.INSTALL FRONT SEAT INNER BELT ASSEMBLY LH
89710
36.INSTALL POSITION CONTROL ECU ASSEMBLY (w/ Memory)