The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during intake manifold removal/installation are shown below.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
22030
1.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
25601
2.REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY
89421
3.REMOVE E.F.I. VACUUM SENSOR ASSEMBLY (MANIFOLD ABSOLUTE PRESSURE SENSOR)
82121
4.DISCONNECT ENGINE WIRE
Remove the bolt.
Detach the wire harness clamp and disconnect the engine wire.
Disconnect the connector.
Remove the 2 bolts.
Detach the 2 wire harness clamps and disconnect the engine wire.
16279
5.DISCONNECT NO. 3 WATER BY-PASS PIPE
Slide the clip and disconnect the No. 2 water by-pass hose from the No. 3 water by-pass pipe.
Using an 8 mm socket wrench, remove the bolt and separate the No. 3 water by-pass pipe from the intake manifold.
17138B
6.REMOVE INTAKE MANIFOLD STAY
Using an 8 mm socket wrench, remove the bolt (A).
Remove the bolt (B).
Detach the guide and remove the intake manifold stay.
23826
7.DISCONNECT NO. 1 FUEL VAPOR FEED HOSE
Slide the clip and disconnect the No. 1 fuel vapor feed hose from the intake manifold.
17111
8.REMOVE INTAKE MANIFOLD
w/o Stud Bolt:
Remove the 5 bolts and intake manifold from the cylinder head sub-assembly.
|
Bolt |
|
Nut |
w/ Stud Bolt:
Remove the 3 bolts, 2 nuts and intake manifold from the cylinder head sub-assembly.
17177
9.REMOVE NO. 1 INTAKE MANIFOLD TO HEAD GASKET
Remove the No. 1 intake manifold to head gasket from the intake manifold.
10.REMOVE VACUUM HOSE
Remove the vacuum hose from the intake manifold.