During self diagnosis of the parking assist ECU, the parking assist ECU sends display mode ID signals to the television camera assembly. This DTC is stored when the output of the television camera assembly does not match the expected output.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C2A6A | Back Camera Response Malfunction | Abnormal response from the television camera assembly | ·
Television camera assembly ·
Parking assist ECU |
When "!" mark is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Clear the DTCs.
Check for DTCs.
DTC C2A6A is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Replace the television camera assembly with a new or normally functioning one.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>TELEVISION CAMERA (for Rear)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Check for DTCs.
DTC C2A6A is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG