The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during television camera assembly removal/installation are shown below.
67939B
1.REMOVE BACK DOOR CENTER GARNISH
67938A
2.REMOVE BACK DOOR SIDE GARNISH LH
67937B
3.REMOVE BACK DOOR SIDE GARNISH RH
Use the same procedure described for the LH side.
69196
4.REMOVE BACK DOOR GRIP BASE
69195A
5.REMOVE BACK DOOR GRIP
Use the same procedure described for the back door grip base.
67750
6.REMOVE BACK DOOR TRIM BOARD ASSEMBLY
76801
7.REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
86790
8.REMOVE TELEVISION CAMERA ASSEMBLY
Disconnect the connector.
Remove the 2 screws.
| *1 | Screw Grommet |
|
Remove in this Direction |
Using pliers, grip the claw of the 2 screw grommets and slide the 2 screw grommets to remove the television camera assembly and 2 screw grommets as shown in the illustration.
9.REMOVE SCREW GROMMET