The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during EGR cooler assembly removal/installation are shown below.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
1.DRAIN ENGINE COOLANT
12601B
2.REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
3.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
4.DISCONNECT ENGINE WIRE
Remove the 3 bolts.
Disconnect the clamp and 4 connectors.
Disconnect the 3 clamps and 6 connectors.
Remove the 2 bolts and 2 nuts.
Disconnect the 2 clamps and 5 connectors.
25680
5.REMOVE EGR COOLER ASSEMBLY
| *1 | No. 4 Water By-pass Hose |
| *2 | No. 3 Water By-pass Hose |
Slide the 2 clips and disconnect the No. 3 water by-pass hose and No. 4 water by-pass hose from the EGR cooler assembly.
Remove the 2 bolts and wire harness clamp bracket from the EGR cooler assembly.
Remove the 2 bolts and 3 nuts and EGR cooler assembly from the cylinder head sub-assembly and EGR valve assembly.
| *1 | EGR Valve Gasket |
| *2 | EGR Cooler Gasket |
| *a | Claw |
Remove the EGR valve gasket from the EGR cooler assembly.
Remove the EGR cooler gasket from the EGR cooler assembly.