Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF SYSTEM
RM3620E _59 Vehicle Exterior _076526 SLIDING ROOF / CONVERTIBLE _0372465 SLIDING ROOF SYSTEM J

SLIDING ROOF / CONVERTIBLE  SLIDING ROOF SYSTEM  Key-off Operation Function Operates even if Operating Conditions are not Satisfied  


DESCRIPTION

The sliding roof ECU (sliding roof drive gear sub-assembly) operates its built-in motor according to the map light sub-assembly (slide/tilt switch) operation. Using the map light sub-assembly (slide/tilt switch), if the sliding roof can be operated normally when 45 seconds or more have elapsed since the ignition switch was turned off, the key-off operation function may be abnormal.

CAUTION / NOTICE / HINT

NOTICE:
·

If the sliding roof ECU (sliding roof drive gear sub-assembly) is removed and reinstalled or replaced, the sliding roof ECU (sliding roof drive gear sub-assembly) must be initialized.

Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>INITIALIZATION

·

The sliding roof system uses the CAN and LIN communication systems. First, confirm that there are no malfunctions in the CAN and LIN communication systems. Refer to How to Proceed with Troubleshooting.

Click hereVehicle Exterior>SLIDING ROOF / CONVERTIBLE>SLIDING ROOF SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING

·

Before replacing the main body ECU (multiplex network body ECU) refer to Service Bulletin.



PROCEDURE

1.CHECK POWER WINDOW CONTROL SYSTEM
a.

Check if the key-off operation function of the power window control system operates normally.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK

OK:

The key-off operation function of the power window control system operates normally.



Result:
Result Proceed to
OK A
NG (for LHD) B
NG (for RHD) C



A

REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)

B

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

C

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)