Home › Engine / Hybrid System › M20A-FKS (ENGINE CONTROL) › ACTIVE CONTROL ENGINE MOUNT (for Rear Side)
RM3620E _51 Engine / Hybrid System _076384 M20A-FKS ENGINE CONTROL _0372633 ACTIVE CONTROL ENGINE MOUNT(for Rear Side) G

M20A-FKS ENGINE CONTROL  ACTIVE CONTROL ENGINE MOUNT(for Rear Side)  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

PROCEDURE

Hide 53895B 1.REMOVE FRONT FENDER SPLASH SHIELD RH

Hide 53896B 2.REMOVE FRONT FENDER SPLASH SHIELD LH

Hide 51441 3.REMOVE NO. 1 ENGINE UNDER COVER

Hide 51420 4.REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY

Hide 12371A 5.INSPECT REAR ENGINE MOUNTING INSULATOR

a.
A433252

Detach the 2 clamps to disconnect the vacuum hose.


b.

Disconnect the vacuum hose.


c.
A433253

Using a vacuum pump, apply vacuum of 80 kPa (600 mmHg, 23.6 in.Hg) and wait for 1 minute.


d.

Check that there is no change in the needle movement of the vacuum pump gauge.

OK:

Vacuum pressure holds.



e.

Check that there is no fluid leakage caused by a break in the diaphragm.


f.

Connect the vacuum hose.


g.

Attach the 2 clamps to install the vacuum hose.


Hide 51420 6.INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY

Hide 53896B 8.INSTALL FRONT FENDER SPLASH SHIELD LH

Hide 53895B 9.INSTALL FRONT FENDER SPLASH SHIELD RH