Before troubleshooting the front camera system, first refer to How to Proceed with Troubleshooting for the pre-collision system.
Click hereVehicle Interior>PRE-COLLISION>PRE-COLLISION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
If a message is displayed on the multi-information display, refer to How to Proceed with Troubleshooting for the pre-collision system.
Click hereVehicle Interior>PRE-COLLISION>PRE-COLLISION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Use these procedures to troubleshoot the front camera system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Measure the auxiliary battery voltage with the ignition switch off.
11 to 14 V
If the voltage is below 11 V, replace or recharge the auxiliary battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
Using the GTS, check if the CAN communication system is functioning normally.
for HV Model:
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for HV Model)>DIAGNOSIS SYSTEM
for Gasoline Model:
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for Gasoline Model)>DIAGNOSIS SYSTEM
CAN communication system is functioning normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for HV Model:
for Gasoline Model:
Check for DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTC C1AA800 is output | B |
| A DTC other than C1AA800 is output | C |
A
B
C
Check for vehicle control history and note any codes that are output.
Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA SYSTEM>VEHICLE CONTROL HISTORY
| Tester Display |
|---|
| Vehicle Control History (RoB) |
Record the vehicle control history.
| Result | Proceed to |
|---|---|
| Vehicle control history is not output | A |
| Vehicle control history other than X2015 and X201C is output | |
| X2015 or X201C is output | B |
A
B
Clear the vehicle control history.
Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA SYSTEM>VEHICLE CONTROL HISTORY
| Tester Display |
|---|
| Vehicle Control History (RoB) |
Recheck for vehicle control history.
Check if the following vehicle control history is output.
Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA SYSTEM>VEHICLE CONTROL HISTORY
| Tester Display |
|---|
| Vehicle Control History (RoB) |
| Result | Proceed to |
|---|---|
| Vehicle control history is not output | A |
| Vehicle control history is output | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Clear the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA SYSTEM>DTC CHECK / CLEAR
Reproduce the detection conditions of the recorded DTC.
Refer to the flowchart for the detection conditions for each of the DTCs.
Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
Recheck for DTCs.
Attempt to duplicate the malfunction and check if the DTCs are output again.
Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTC is output | B |
A
B