83320
1.INSTALL FUEL SENDER GAUGE ASSEMBLY
Attach the claw and install the fuel sender gauge assembly.
Attach the 2 clamps and connect the wire harness.
Do not damage the wire harness.
Attach the clamp and connect the wire harness.
Do not damage the wire harness.
Connect the 2 connectors to the fuel suction plate sub-assembly.
77020A
2.INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
3.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
65351A
4.INSTALL BATTERY HOLE COVER
58416K
5.INSTALL REAR NO. 2 FLOOR BOARD
58410B
6.INSTALL DECK BOARD ASSEMBLY