This DTC is stored when a malfunction occurs in the speakers.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15C3 | Speaker Output Short | A short is detected in the speaker output circuit | ·
Harness or connector ·
Speaker ·
Radio and display receiver assembly*1 ·
Stereo Component Amplifier assembly*2 |
*1: for 6 Speakers
*2: for 9 Speakers
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio and display receiver assembly may not operate normally.
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Clear the DTCs.
Recheck for DTCs and check that no DTCs are output.
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Choose the model to be inspected.
| Result | Proceed to |
|---|---|
| for 6 Speakers | A |
| for 9 Speakers | B |
A
B
Disconnect the G4 radio and display receiver assembly connector.
Disconnect the I1 and J1 front No. 1 speaker assembly connectors.
Disconnect the G5 and G6 front No. 2 speaker assembly connectors.
Disconnect the K1 and L1 rear speaker assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G4-1 (FR+) - G5-4 (TWR+) | Always | Below 1 Ω |
| G4-6 (FR-) - G5-2 (TWR-) | Always | Below 1 Ω |
| G4-2 (FL+) - G6-4 (TWL+) | Always | Below 1 Ω |
| G4-7 (FL-) - G6-2 (TWL-) | Always | Below 1 Ω |
| G5-3 (+) - I1-2 (+) | Always | Below 1 Ω |
| G5-1 (-) - I1-1 (-) | Always | Below 1 Ω |
| G6-3 (+) - J1-2 (+) | Always | Below 1 Ω |
| G6-1 (-) - J1-1 (-) | Always | Below 1 Ω |
| G4-4 (RR+) - K1-2 (+) | Always | Below 1 Ω |
| G4-9 (RR-) - K1-1 (-) | Always | Below 1 Ω |
| G4-3 (RL+) - L1-2 (+) | Always | Below 1 Ω |
| G4-8 (RL-) - K1-1 (-) | Always | Below 1 Ω |
| G4-1 (FR+) - Body ground | Always | 10 kΩ or higher |
| G4-6 (FR-) - Body ground | Always | 10 kΩ or higher |
| G4-2 (FL+) - Body ground | Always | 10 kΩ or higher |
| G4-7 (FL-) - Body ground | Always | 10 kΩ or higher |
| G5-3 (+) - Body ground | Always | 10 kΩ or higher |
| G5-1 (-) - Body ground | Always | 10 kΩ or higher |
| G6-3 (+) - Body ground | Always | 10 kΩ or higher |
| G6-1 (-) - Body ground | Always | 10 kΩ or higher |
| G4-4 (RR+) - Body ground | Always | 10 kΩ or higher |
| G4-9 (RR-) - Body ground | Always | 10 kΩ or higher |
| G4-3 (RL+) - Body ground | Always | 10 kΩ or higher |
| G4-8 (RL-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL
Inspect the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the rear speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>REMOVAL
Inspect the rear speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the front No. 2 speaker assembly with a new or known good one.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>REMOVAL
Clear the DTCs.
Recheck for DTCs and check that no DTCs are output.
No DTCs are output
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the M2 stereo component amplifier assembly connector.
Disconnect the I1 and J1 front No. 1 speaker assembly connectors.
Disconnect the G7 and G8 front No. 2 speaker assembly connectors.
Disconnect the G5 and G6 front No. 3 speaker assembly connectors.
Disconnect the K1 and L1 rear speaker assembly connectors.
Disconnect the N1 rear No. 2 speaker assembly connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M2-13 (TWR+) - G7-1 (+) | Always | Below 1 Ω |
| M2-28 (TWR-) - G7-2 (-) | Always | Below 1 Ω |
| M2-10 (TWL+) - G8-1 (+) | Always | Below 1 Ω |
| M2-25 (TWL-) - G8-2 (-) | Always | Below 1 Ω |
| M2-9 (FR+) - G5-4 (TWR+) | Always | Below 1 Ω |
| M2-24 (FR-) - G5-2 (TWR-) | Always | Below 1 Ω |
| G5-3 (+) - I1-2 (+) | Always | Below 1 Ω |
| G5-1 (-) - I1-1 (-) | Always | Below 1 Ω |
| M2-14 (FL+) - G6-4 (TWL+) | Always | Below 1 Ω |
| M2-29 (FL-) - G6-2 (TWL-) | Always | Below 1 Ω |
| G6-3 (+) - J1-2 (+) | Always | Below 1 Ω |
| G6-1 (-) - J1-1 (-) | Always | Below 1 Ω |
| M2-12 (RR+) - K1-2 (+) | Always | Below 1 Ω |
| M2-27 (RR-) - K1-1 (-) | Always | Below 1 Ω |
| M2-11 (RL+) - L1-2 (+) | Always | Below 1 Ω |
| M2-26 (RL-) - L1-1 (-) | Always | Below 1 Ω |
| M2-15 (WFR+) - N1-4 (MF+) | Always | Below 1 Ω |
| M2-30 (WFR-) - N1-1 (WF-) | Always | Below 1 Ω |
| M2-8 (WFL+) - N1-2 (WF+) | Always | Below 1 Ω |
| M2-23 (WFL-) - N1-3 (WF-) | Always | Below 1 Ω |
| M2-13 (TWR+) - Body ground | Always | 10 kΩ or higher |
| M2-28 (TWR-) - Body ground | Always | 10 kΩ or higher |
| M2-10 (TWL+) - Body ground | Always | 10 kΩ or higher |
| M2-25 (TWL-) - Body ground | Always | 10 kΩ or higher |
| M2-9 (FR+) - G5-4 (TWR+) | Always | 10 kΩ or higher |
| M2-24 (FR-) - Body ground | Always | 10 kΩ or higher |
| G5-3 (+) - Body ground | Always | 10 kΩ or higher |
| G5-1 (-) - Body ground | Always | 10 kΩ or higher |
| M2-14 (FL+) - Body ground | Always | 10 kΩ or higher |
| M2-29 (FL-) - Body ground | Always | 10 kΩ or higher |
| G6-3 (+) - Body ground | Always | 10 kΩ or higher |
| G6-1 (-) - Body ground | Always | 10 kΩ or higher |
| M2-12 (RR+) - Body ground | Always | 10 kΩ or higher |
| M2-27 (RR-) - Body ground | Always | 10 kΩ or higher |
| M2-11 (RL+) - Body ground | Always | 10 kΩ or higher |
| M2-26 (RL-) - Body ground | Always | 10 kΩ or higher |
| M2-15 (WFR+) - Body ground | Always | 10 kΩ or higher |
| M2-30 (WFR-) - Body ground | Always | 10 kΩ or higher |
| M2-8 (WFL+) - Body ground | Always | 10 kΩ or higher |
| M2-23 (WFL-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL
Inspect the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 2 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>REMOVAL
Inspect the front No. 2 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the rear speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>REMOVAL
Inspect the rear speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the rear No. 2 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>LUGGAGE SPEAKER>REMOVAL
Inspect the rear No. 2 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>LUGGAGE SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the front No. 3 speaker assembly with a new or known good one.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>PILLAR SPEAKER>REMOVAL
Clear the DTCs.
Recheck for DTCs and check that no DTCs are output.
No DTCs are output
| Proceed to |
|---|
| OK |
| NG |
OK
NG