Home › Engine / Hybrid System › A25A-FXS (FUEL) › FUEL SENDER GAUGE ASSEMBLY (w/ Canister Pump Module)
RM3620E _51 Engine / Hybrid System _076684 A25A-FXS FUEL _0375750 FUEL SENDER GAUGE ASSEMBLY(w/ Canister Pump Module) A

A25A-FXS FUEL  FUEL SENDER GAUGE ASSEMBLY(w/ Canister Pump Module)  INSTALLATION  


PROCEDURE

Hide 83320 1.INSTALL FUEL SENDER GAUGE ASSEMBLY

a.

Attach the 2 claws and install the fuel sender gauge assembly.


b.

Attach the clamp and connect the wire harness.

NOTICE:

Do not damage the wire harness.



c.

Attach the clamp and connect the wire harness.

NOTICE:

Do not damage the wire harness.



d.

Connect the 3 connectors to the fuel suction plate sub-assembly.


Hide 77020A 2.INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY

Hide 3.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 65351A 4.INSTALL BATTERY HOLE COVER

Hide 58416K 5.INSTALL REAR NO. 2 FLOOR BOARD

Hide 58410B 6.INSTALL DECK BOARD ASSEMBLY