Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR
RM3620E _54 Brake _076410 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0376839 STEERING ANGLE SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

A lock pin is installed to a new steering sensor. Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly.


PROCEDURE

Hide 84306 1.INSPECT SPIRAL CABLE SUB-ASSEMBLY

Hide 89245B 2.INSTALL STEERING SENSOR

a.
C409080C05
0.344,0.719 0.427,0.719 0.427,0.719 0.698,1.208 true 1.958,0.177 2.042,0.177 2.042,0.177 2.271,0.635 true 1.74,0.615 1.823,0.615 1.823,0.615 2.24,0.823 true 2.719,1.031 2.99,0.542 2.99,0.542 3.073,0.542 true 1.854,1.854 1.938,1.854 1.938,1.854 2.354,1.292 true 1.542,0.5 1.75,0.698 0.208,0.198 10 false *a 3.146,0.458 3.333,0.667 0.188,0.208 10 false *b 1.729,0.073 2.042,0.229 0.313,0.156 10 false *c 0.125,0.615 0.313,0.823 0.188,0.208 10 false *b 1.646,1.729 1.906,1.948 0.26,0.219 10 false *a
*a Guide
*b Pin
*c Lock Pin


Align the 2 pins and 2 guides, and attach the 6 claws to install the steering sensor to the spiral cable sub-assembly.

NOTICE:
·

Do not remove the lock pin before the steering sensor is installed to the spiral cable sub-assembly.

·

Do not damage the pins of the spiral cable sub-assembly or guides of the steering sensor.

·

The spiral cable sub-assembly can be rotated up to 30° even when the interlock is engaged. Therefore, make sure that both guides are aligned properly when installing the steering sensor to the spiral cable sub-assembly.




b.
C398599

Remove the lock pin from the steering sensor.


Hide 3.INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY