Use the same procedure as for the LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
87130D
1.REMOVE BLOWER ASSEMBLY
87201B
2.REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY
88897P
3.REMOVE ASPIRATOR (for Automatic Air Conditioning System)
88625Q
4.REMOVE COOLER THERMISTOR (ROOM TEMPERATURE SENSOR) (for Automatic Air Conditioning System)
88898D
5.REMOVE GROMMET (for Manual Air Conditioning System)
Detach the claw and remove the grommet.
88539J
6.REMOVE DRAIN COOLER HOSE
88539C
7.REMOVE NO. 2 COOLER UNIT DRAIN HOSE (Available as Supply Part)
82210K
8.REMOVE AIR CONDITIONING HARNESS ASSEMBLY
Disconnect each connector.
| *A | for LHD | *B | for RHD |
| *a | Clamp | *b | Guide |
Detach the clamp and guide and remove the air conditioning harness assembly.
87050C
9.REMOVE NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
| *A | for Automatic Air Conditioning System |
| *B | for Manual Air Conditioning System |
Remove the 3 screws.
Detach the guide and remove the No. 1 air conditioning radiator damper servo sub-assembly.
87050D
10.REMOVE NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY
88897M
11.REMOVE HEATER PIPE GROMMET
87124B
12.REMOVE HEATER CLAMP
87107A
13.REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY
88899L
14.REMOVE COOLING UNIT PARTS
88515
15.REMOVE COOLER EXPANSION VALVE
| *A | for Type A |
| *B | for Type B |
Using a 4 mm hexagon socket wrench, remove the 2 hexagon bolts and cooler expansion valve.
Remove the 2 O-rings from the No. 1 cooler evaporator sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent the entry of moisture and foreign matter.
88501
16.REMOVE NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
Remove the 2 screws.
| *a | No. 1 Cooler Thermistor Lead Wire | - | - |
|
Detach lead wire from guide | - | - |
Detach the claw and guide, and then while detaching the lead wire of the No. 1 cooler thermistor from the guide, separate the upper heater case with No. 1 cooler evaporator sub-assembly from the lower heater case as shown in the illustration.
Detach the guide.
| *A | for Type A | *B | for Type B |
Remove the No. 1 cooler evaporator sub-assembly with No. 1 cooler thermistor from the upper heater case.
88625
17.REMOVE NO. 1 COOLER THERMISTOR
87114B
18.REMOVE HEATER COVER