The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during radiator shutter sub-assembly removal/installation are shown below.
1.REMOVE FRONT BUMPER ASSEMBLY
except Off Road Package:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (except Off Road Package)>REMOVAL
for Off Road Package:
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER (except Off Road Package)>REMOVAL
52614
2.REMOVE FRONT BUMPER NO. 2 ENERGY ABSORBER (for HV Model)
53019F
3.REMOVE RADIATOR SHUTTER SUB-ASSEMBLY
Disconnect the 2 connectors.
Remove the 3 nuts.
|
Remove in this Direction |
Remove the radiator shutter sub-assembly as shown in the illustration.
53189B
4.REMOVE RADIATOR SHUTTER SUPPORT BRACKET LH
Perform the following procedure only when replacement of a radiator shutter support bracket LH is necessary.
Remove the 2 nuts and radiator shutter support bracket LH.
53188C
5.REMOVE RADIATOR SHUTTER SUPPORT BRACKET RH
Perform the following procedure only when replacement of a radiator shutter support bracket RH is necessary.
Remove the 2 nuts and radiator shutter support bracket RH.