Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
75860A
1.INSTALL BODY ROCKER PANEL MOULDING ASSEMBLY LH
Install a new grommet.
Use the same procedure for the other side.
Attach the clip to install the body rocker panel moulding assembly LH as shown in the illustration.
|
Install in this Direction | - | - |
Install 8 new clips labeled B.
Install the 2 clips labeled A.
| *a | Clip A | *b | Clip B |
Install the 2 screws.
Remove the protective tape.
75874
2.INSTALL QUARTER PANEL WHEEL OPENING MOULDING LH
65632B
3.INSTALL REAR WHEEL FRONT HOUSE PLATE LH
76902A
4.INSTALL SIDE MUDGUARD SUB-ASSEMBLY LH