Use the same procedure for the RH and LH side.
The following procedure is for the LH side.
76902A
1.REMOVE SIDE MUDGUARD SUB-ASSEMBLY LH
65632B
2.REMOVE REAR WHEEL FRONT HOUSE PLATE LH
75874
3.REMOVE QUARTER PANEL WHEEL OPENING MOULDING LH
75860A
4.REMOVE BODY ROCKER PANEL MOULDING ASSEMBLY LH
Put protective tape around the body rocker panel moulding assembly LH.
|
Protective Tape | - | - |
Remove the 2 screws.
Remove the 2 clips labeled A.
Remove the 8 clips labeled B.
Using a screwdriver with its tip wrapped with protective tape, detach the claw as shown in the illustration.
Using needle-nose pliers, detach the claw to remove the clip B as shown in the illustration
| *a | Clip A | *b | Clip B |
|
Protective Tape |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
|
Remove in this Direction (3) |
|
Insert Screwdriver Here | - | - |
Detach the clip and remove the body rocker panel moulding assembly LH in the order shown in the illustration.
|
Remove in this Direction |
|
Place Hand Here |
Using a clip remover, remove the grommet.
Use the same procedure for the other side.