The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the multiplex network door ECU removal/installation are shown below.
67939B
1.REMOVE BACK DOOR CENTER GARNISH
67938A
2.REMOVE BACK DOOR SIDE GARNISH LH
67937B
3.REMOVE BACK DOOR SIDE GARNISH RH
Use the same procedure described for the LH side.
69196
4.REMOVE BACK DOOR GRIP BASE
69195A
5.REMOVE BACK DOOR GRIP
Use the same procedure described for the back door grip base.
67750
6.REMOVE BACK DOOR TRIM BOARD ASSEMBLY
89222A
7.REMOVE MULTIPLEX NETWORK DOOR ECU
|
Bolt |
|
Connector |
Remove the 2 bolts.
Detach the guide and remove the multiplex network door ECU.
Disconnect the 2 connectors.
Do not subject the multiplex network door ECU to strong impacts or force, and do not drop it.
Do not reuse the multiplex network door ECU that has been dropped.