1.INSPECT AND ADJUST BRAKE PEDAL HEIGHT
Remove the accelerator pedal assembly.
for A25A-FKS:
Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>ACCELERATOR PEDAL>REMOVAL
for M20A-FKS:
Click hereEngine / Hybrid System>M20A-FKS (ENGINE CONTROL)>ACCELERATOR PEDAL>REMOVAL
Check the brake pedal height.
Perform checks and adjustments with the service hole carpet rolled back.
Measure the shortest distance between the brake pedal pad surface and front floor footrest as shown in the illustration.
| *1 | Brake Pedal Pad | - | - |
| *a | Brake Pedal Height | *b | Measuring Plane of Floor Panel |
|
Service Hole | - | - |
161.3 to 177.3 mm (6.36 to 6.98 in.)
If the brake pedal height is not as specified, inspect and adjust the push rod length according to the procedure below.
Adjust the push rod length.
| *1 | Lock Nut |
| *2 | Stop Light Switch Assembly |
| *3 | Floor Panel |
| *a | Brake Pedal Height |
Remove the stop light switch assembly.
Click hereVehicle Exterior>LIGHTING (EXT)>STOP LIGHT SWITCH>REMOVAL
Loosen the lock nut.
Adjust the brake pedal height by turning the push rod.
161.3 to 177.3 mm (6.36 to 6.98 in.)
Tighten the lock nut.
Install the stop light switch assembly.
Click hereVehicle Exterior>LIGHTING (EXT)>STOP LIGHT SWITCH>INSTALLATION
Install the accelerator pedal assembly.
for A25A-FKS:
Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>ACCELERATOR PEDAL>INSTALLATION
for M20A-FKS:
Click hereEngine / Hybrid System>M20A-FKS (ENGINE CONTROL)>ACCELERATOR PEDAL>INSTALLATION
2.INSPECT BRAKE PEDAL FREE PLAY
Stop the engine and firmly depress the brake pedal several times until no vacuum is left in the brake booster assembly.
| *a | Brake Pedal Free Play |
Depress the brake pedal until a slight resistance is felt. Measure the distance as shown in the illustration.
1.0 to 6.0 mm (0.0394 to 0.236 in.)
If the brake pedal free play is not as specified, check the stop light switch clearance.
Click hereVehicle Exterior>LIGHTING (EXT)>STOP LIGHT SWITCH>INSTALLATION
If the brake pedal free play is as specified, proceed to the Inspect Brake Pedal Reserve Distance procedure.
3.INSPECT BRAKE PEDAL RESERVE DISTANCE
With the engine running, depress the brake pedal and measure the brake pedal reserve distance as shown in the illustration.
Perform checks with the service hole carpet rolled back.
| *1 | Brake Pedal Pad | - | - |
| *a | Brake Pedal Reserve Distance | *b | Measuring Plane of Floor Panel |
|
Service Hole | - | - |
| Front Brake | Specification |
|---|---|
| Front Brake (except 2-Pot Caliper) | 142 mm (5.60 in.) or more |
| Front Brake (for 2-Pot Caliper) | 143 mm (5.63 in.) or more |
If the distance is not as specified, troubleshoot the brake system.
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE SYSTEM (w/ Vacuum Brake Booster)>PROBLEM SYMPTOMS TABLE