Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM (w/o Vacuum Brake Booster)
RM3620E _54 Brake _076413 PARKING BRAKE _0379234 ELECTRIC PARKING BRAKE SYSTEM(w/o Vacuum Brake Booster) C

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM(w/o Vacuum Brake Booster)  C1245  Deceleration Sensor  


DESCRIPTION

The parking brake ECU assembly receives vehicle tilt information from the deceleration sensor (airbag sensor assembly) via CAN communication.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory Note
C1245 Deceleration Sensor One of the following conditions is met:
1.

An error signal is sent from the deceleration sensor (airbag sensor assembly) for approx. 0.3 seconds.

2.

Vehicle speed between 30 km/h (19 mph) or more until just before the vehicle stops (exceeds 0 km/h (0 mph) but less than 1 km/h (1 mph)) and the difference between the maximum and minimum value of the G sensor is less than 0.288 m/s2 and the malfunction repeats 16 times.

3.

The power switch is on (IG), the difference between the output values for G sensor 1 and 2 is 5.884 m/s2 or more for 60 seconds.


Deceleration sensor (airbag sensor assembly) Yes An electric parking brake system malfunction is displayed on the multi-information display.

DTC Detection Condition Combination Table: C1245
Vehicle Condition
Pattern 1 Pattern 2 Pattern 3
Diagnosis Condition Power switch on (IG) ○ - ○
From when the vehicle speed is 30 km/h (19 mph) or more until just before the vehicle stops (exceeds 0 km/h (0 mph), but below 1 km/h (1 mph)) - ○ -
Malfunction Status Malfunction signal input from deceleration sensor (airbag sensor assembly) ○ - -
The difference between the maximum and minimum value of the deceleration sensor (airbag sensor assembly) is less than 0.288 m/s2 - ○ -
The difference between the output values for deceleration sensor (airbag sensor assembly) 1 and 2 is 5.884 m/s2 or more - - ○
Detection Time Approximately 0.3 seconds Repeats 16 times 60 seconds
Trip Count 1 trip 1 trip 1 trip

HINT:

If the conditions match either of these patterns, a DTC will be output.


CAUTION / NOTICE / HINT

NOTICE:

When replacing the airbag sensor assembly, perform calibration, initialization or registration.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


PROCEDURE

1.CHECK DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM (w/o Vacuum Brake Booster))
a.

Check for DTC.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (w/o Vacuum Brake Booster)>DTC CHECK / CLEAR

Chassis > ABS/VSC/TRC > Trouble Codes
50001 105
Result:
Proceed to
DTC is not output
DTC is output




DTC is not output

2.CHECK DTC (ELECTRIC PARKING BRAKE SYSTEM (w/o Vacuum Brake Booster))

DTC is output

2.CHECK DTC (ELECTRIC PARKING BRAKE SYSTEM (w/o Vacuum Brake Booster))
a.

Clear the DTC.

Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM (w/o Vacuum Brake Booster)>DTC CHECK / CLEAR

Chassis > Electric Parking Brake > Clear DTCs
50002 184

b.

Turn the power switch off.


c.

Check for DTC.

Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM (w/o Vacuum Brake Booster)>DTC CHECK / CLEAR

Chassis > Electric Parking Brake > Trouble Codes
50001 184

Result:
Proceed to
DTC is output
DTC is not output



DTC is output

DTC is not output